導入
This manual provides comprehensive instructions for the setup, operation, maintenance, and troubleshooting of your Sharp XE-A207B Electronic Thermal Cash Register. Please read this manual thoroughly before using the device to ensure proper functionality and longevity. Keep this manual for future reference.
Figure 1: Sharp XE-A207B Electronic Thermal Cash Register. This image shows the complete unit, including the main register body, integrated thermal printer, customer display, operator display, and cash drawer.
1. セットアップと初期設定
1.1 開梱と検査
すべての部品を梱包から慎重に取り出してください。梱包リストに記載されているすべての部品が揃っていて、損傷がないことを確認してください。梱包は、将来の輸送や保管のために保管してください。
1.2電源接続
- Ensure the cash register is placed on a stable, flat surface.
- Connect the power cord to the power input port on the rear of the cash register.
- 電源コードのもう一方の端を接地されたコンセントに差し込みます。
- Turn on the main power switch, typically located on the side or rear of the unit.
1.3 ロール紙の取り付け
- ラッチを持ち上げてプリンターのカバーを開きます。
- Insert a new thermal paper roll, ensuring the paper feeds from the bottom and the leading edge is straight.
- Pull a small amount of paper past the cutting edge.
- プリンターのカバーをカチッと音がするまでしっかりと閉じます。
1.4 Initial Date and Time Setting
Upon first power-on, the register may prompt for date and time settings. Follow the on-screen instructions or refer to the programming section for detailed steps on setting the correct date and time.
1.5 キャッシュドロワー接続
Connect the cash drawer cable to the designated port on the rear of the cash register. The cash drawer will automatically open during specific transactions (e.g., cash sales, no-sale operations).
2. 操作手順
2.1 Basic Sales Transaction
- Turn the Mode Switch to the 登録 (Register) position.
- Enter the item price using the numeric keypad.
- Press the appropriate Department key (e.g., 部門1). Repeat for additional items.
- To finalize the sale, press the 合計 鍵。
- Enter the amount received from the customer.
- を押す 現金 key. The register will print a receipt and display the change due.
2.2 Using PLU (Price Look-Up) Items
For items programmed with PLU codes:
- Turn the Mode Switch to 登録.
- Enter the PLU number.
- を押す プル key. The item's pre-programmed price will be registered.
- Proceed with the transaction as described in Section 2.1.
2.3 Voiding and Refunds
- Voiding an Item (before TOTAL): Enter the item price, press the Department key, then press the VOID 鍵。
- Refund (after TOTAL): Turn the Mode Switch to 返金 (if available) or 登録 そして、 返金 function. Enter the amount to be refunded and press the 現金 key. Consult the programming guide for specific refund procedures.
2.4 Daily Reports (X-Report and Z-Report)
- X-Report (Reading Report): Provides a current summary of sales without clearing totals. Turn the Mode Switch to Xを押して、 合計 鍵。
- Z-Report (Reset Report): Clears daily sales totals and prints a comprehensive summary. This report should be run at the end of each business day. Turn the Mode Switch to Zを押して、 合計 鍵。
3. メンテナンス
3.1 ユニットのクリーニング
Regular cleaning helps maintain the performance and appearance of your cash register.
- 清掃する前に電源コードを抜いてください。
- 外側の表面を柔らかい布で拭きます。amp 布で拭いてください。研磨剤や溶剤は使用しないでください。
- Use a soft brush or compressed air to remove dust and debris from the keypad and printer area.
- Clean the thermal print head periodically with a specialized thermal printer cleaning pen or isopropyl alcohol on a cotton swab. Allow to dry completely before use.
3.2 ロール紙の交換
Refer to Section 1.3 for detailed instructions on replacing the thermal paper roll.
4。 トラブルシューティング
This section addresses common issues you might encounter with your Sharp XE-A207B cash register. For problems not listed here, contact customer support.
| 問題 | 考えられる原因 | 解決 |
|---|---|---|
| Register does not power on. | Power cord disconnected; power switch off; power outlet issue. | 電源コードの接続を確認し、電源スイッチがオンになっていることを確認し、別のデバイスでコンセントをテストします。 |
| Printer not printing or printing faintly. | Paper roll empty or incorrectly installed; non-thermal paper used; print head dirty. | Replace paper roll correctly (ensure thermal side is facing print head); use thermal paper only; clean print head. |
| Cash drawer does not open. | Drawer not connected; drawer lock engaged; mechanical obstruction. | Verify drawer cable connection; ensure drawer is unlocked; check for obstructions inside or around the drawer. |
| ディスプレイにエラーメッセージが表示されます。 | Operational error; programming error. | Refer to the specific error code in the full programming manual (if available) or restart the unit. |
5. 仕様
The following are key specifications for the Sharp XE-A207B Electronic Thermal Cash Register:
- モデル： XE-A207B
- ブランド： シャープ
- プリンタータイプ: サーマルプリンター
- 画面： Operator and Customer Displays
- Cash Drawer: Integrated, secure cash drawer
- 接続性: (Not specified in input, assume standard power and drawer connection)
- 発売日: 7年2023月XNUMX日
6. 保証とサポート
保証情報については、製品に付属の保証書を参照するか、シャープの公式ウェブサイトをご覧ください。 website. For technical support, service, or spare parts availability, please contact your local Sharp authorized service center or the retailer from whom you purchased the product.
注記： Spare part information is not available or provided directly within this product's specifications as per initial data.
