導入
The Strymon Sunset is a versatile dual overdrive pedal designed to provide a wide range of classic overdrive and distortion tones. It features two independent channels, A and B, each offering distinct overdrive circuits, allowing for flexible tone shaping and stacking options. This manual provides detailed instructions on setting up, operating, and maintaining your Sunset pedal.
設定
Follow these steps to properly set up your Strymon Sunset pedal:
- 電源接続: 標準の9V DC電源（センターマイナス、200mA以上）を 9VDC input jack on the rear panel. Ensure the power supply meets the specified voltage および現在の要件。
- 入力接続: ギターやその他の楽器を IN jack on the rear panel using a standard 1/4-inch instrument cable.
- 出力接続: 接続する 外 jack on the rear panel to your amp標準の 1/4 インチ楽器ケーブルを使用して、信号チェーン内のリファイアーまたは次のペダルに接続します。
- オプションの接続:
- Expression Pedal (EXP): For real-time control over parameters, connect an expression pedal to the 経験値 ジャック。
- Favorite Switch (FAV): Connect an external favorite switch to the お気に入り jack to recall a saved preset.
Figure 1: Rear panel connections of the Strymon Sunset pedal. This view highlights the IN, OUT, FAV, EXP, and 9VDC power input jacks, along with the B->A and A+B switches.
操作手順
The Strymon Sunset features two independent overdrive channels, A and B, each with unique voicings and controls. Understanding these controls is key to unlocking the pedal's full potential.
Figure 2: Top panel controls of the Strymon Sunset pedal. This image displays the LEVEL, DRIVE, and TONE knobs for both channels, along with the A and B circuit type switches and footswitches.
フロントパネルコントロール
- Channel A Controls:
- LEVEL A: Adjusts the output volume of Channel A.
- DRIVE A: Controls the amount of gain/overdrive for Channel A.
- TONE A: Shapes the tonal character of Channel A, typically acting as a high-cut filter.
- A Circuit Switch: Selects between three distinct overdrive circuits for Channel A:
- Ge (Germanium): Smooth, warm, and dynamic overdrive, reminiscent of classic germanium diode circuits.
- テキサス： Mid-focused, bluesy overdrive with a distinct character.
- 高音： A treble booster circuit, ideal for pushing an already overdriven amp or adding sparkle.
- Channel B Controls:
- LEVEL B: Adjusts the output volume of Channel B.
- DRIVE B: Controls the amount of gain/overdrive for Channel B.
- TONE B: Shapes the tonal character of Channel B.
- B Circuit Switch: Selects between three distinct overdrive circuits for Channel B:
- 2年tage: A classic two-stage soft-clipping overdrive.
- 難しい： A harder clipping overdrive with increased compression and sustain.
- JFET: A JFET-based circuit offering a more amp-like, natural overdrive.
- フットスイッチ:
- フットスイッチ: Engages or bypasses Channel A. The corresponding LED indicates its status.
- B フットスイッチ: Engages or bypasses Channel B. The corresponding LED indicates its status.
リアパネルスイッチ
- B->A / A+B Switch: This switch determines the stacking order when both channels are engaged:
- B->A: Channel B feeds into Channel A. This is useful for boosting Channel A with Channel B's gain.
- A + B： Channels A and B run in parallel. This allows for blending the two distinct tones.
- BRIGHTスイッチ: A global switch that adds a subtle high-end boost to the overall output.
- +: Engages the bright boost.
- -: Disengages the bright boost.
メンテナンス
To ensure the longevity and optimal performance of your Strymon Sunset pedal, follow these maintenance guidelines:
- クリーニング： Use a soft, dry cloth to wipe down the pedal's enclosure. Avoid using abrasive cleaners or solvents, as they may damage the finish or internal components.
- ストレージ： ペダルは、直射日光、極端な温度、高湿度を避け、涼しく乾燥した場所に保管してください。
- 電源： Always use a regulated 9V DC center-negative power supply that meets the pedal's current requirements (200mA minimum). Using an incorrect power supply can damage the unit and void the warranty.
- 接続: すべてのケーブル接続部が摩耗していないか定期的に点検してください。ジャックにほこりやゴミが付着していないことを確認してください。
トラブルシューティング
If you encounter issues with your Strymon Sunset pedal, refer to the following common problems and solutions:
| 問題 | 考えられる原因 | 解決 |
|---|---|---|
| 音が出ない、または信号が弱い。 | Incorrect power supply, faulty cables, incorrect connections, pedal bypassed. |
|
| 不要なノイズやハム音。 | グランドループ、電源障害、他の電子機器からの干渉。 |
|
| LEDが点灯しません。 | No power, pedal malfunction. |
|
仕様
| モデル： | Sunset Dual Overdrive |
| 電力要件: | 9V DC、センターマイナス、最小200mA |
| 信号フォーマット： | アナログ |
| ハードウェアインターフェイス： | HP-HSC |
| 寸法（長さ×幅×高さ）： | 8 x 5 x 4 インチ (20.3 x 12.7 x 10.2 cm) |
| 重さ： | 1.34ポンド（0.61kg） |
| 色： | Red, Silver |
| ASIN: | B0875MSLCJ |
| 発売日: | 16年2020月XNUMX日 |
保証とサポート
Strymon products are built with high-quality components and undergo rigorous testing. For information regarding warranty coverage, product registration, and technical support, please visit the official Strymon webご購入の際は、ウェブサイトをご覧いただくか、カスタマーサービスまでお問い合わせください。保証請求の際は、購入証明としてレシートを保管してください。
Strymon Official Webサイト： www.strymon.net
