1. はじめに
The Xilence Performance C CPU Cooler XC032 is engineered to provide efficient and quiet cooling for high-performance Intel CPUs. Featuring a 92mm PWM fan with fluid bearing, it ensures optimal airflow while maintaining low noise levels. This cooler is designed for compatibility with various Intel sockets and includes a stable mounting backplate for secure installation.
2. 安全情報
- 内部コンポーネントの取り付けやメンテナンスを行う前に、必ずコンピューターの電源を切ってください。
- Handle the CPU cooler and other components with care to avoid damage to sensitive parts.
- Ensure proper grounding to prevent electrostatic discharge (ESD) which can damage electronic components.
- お子様の手の届かない場所に保管してください。
- 動作中はファンの空気の流れを妨げないでください。
- Refer to your motherboard's manual for specific CPU cooler installation guidelines.
3. パッケージ内容
以下にリストされているすべてのコンポーネントがパッケージに含まれていることを確認してください。
- I250PWM Intel CPU Cooler
- 92 mm PWM Fan (integrated)
- ファンネジ
- サーマルペースト（塗布済みまたはチューブ入り）
- バックプレート
Figure 3.1: All components included in the Xilence Performance C CPU Cooler XC032 package.
4. セットアップとインストール
Follow these general steps for installing your Xilence Performance C CPU Cooler. Specific steps may vary slightly depending on your motherboard and PC case.
- マザーボードを準備します。 Place the motherboard on a non-conductive surface. If a CPU is already installed, ensure it is properly seated in the socket.
- バックプレートを取り付けます。 Position the included backplate on the rear side of the motherboard, aligning its holes with the CPU cooler mounting holes around the CPU socket. This cooler is compatible with Intel sockets 1150, 1151, 1155, and 1156.
Figure 4.1: CPU Cooler with separate backplate.
- サーマルペーストを塗布します（事前に塗布されていない場合）。 If your cooler does not have thermal paste pre-applied to its base, apply a small amount (pea-sized dot) to the center of the CPU's integrated heat spreader (IHS).
- クーラーを取り付ける: Carefully place the CPU cooler onto the CPU, aligning the mounting screws with the holes in the backplate. Press down gently and evenly.
- クーラーを固定する: Tighten the four spring-loaded screws in a diagonal pattern (e.g., top-left, bottom-right, top-right, bottom-left) until they are finger-tight. Do not overtighten. The spring mechanism ensures even pressure.
図4.2: 角度付き view of the cooler showing the fan and heatsink.
- ファンケーブルを接続します。 Locate the 4-pin PWM fan header on your motherboard (usually labeled "CPU_FAN") and connect the cooler's 4-pin cable to it. Ensure the connector is fully seated.
- 最終チェック: Double-check all connections and ensure the cooler is securely mounted and not obstructing any other components.
5. 操作手順
The Xilence Performance C CPU Cooler XC032 operates automatically via its PWM (Pulse Width Modulation) control. The motherboard's BIOS/UEFI or operating system software will regulate the fan speed based on the CPU temperature, ensuring optimal cooling performance and noise levels.
- 自動ファン制御: The 4-pin PWM connection allows the motherboard to dynamically adjust the fan speed (RPM) according to the CPU's thermal load. This results in quieter operation during low-load tasks and increased cooling power when needed.
- 監視： You can monitor CPU temperatures and fan speeds using motherboard monitoring software or utilities provided by your operating system.
- 騒音レベル: The fan is designed for quiet operation, with a typical noise level of 26.4 dB.
図5.1：上 view of the CPU cooler fan.
6. メンテナンス
定期的なメンテナンスを行うことで、CPU クーラーの寿命が長くなり、最適なパフォーマンスが確保されます。
- ほこりの除去: Periodically (e.g., every 3-6 months), use compressed air to gently blow dust out of the heatsink fins and fan blades. Ensure the fan is not spinning rapidly during this process to prevent damage to the bearings.
- ファンのクリーニング: If dust accumulates on the fan blades, carefully wipe them with a soft, dry cloth.
- サーマルペースト: The thermal paste typically lasts for several years. If you notice significantly higher CPU temperatures over time, consider reapplying fresh thermal paste after carefully cleaning the old paste from both the CPU and cooler base.
- 検査： Regularly inspect the mounting screws to ensure they remain secure.
7。 トラブルシューティング
CPU クーラーに問題が発生した場合は、次の一般的な問題と解決策を参照してください。
| 問題 | 考えられる原因 | 解決 |
|---|---|---|
| ファンが回転しない | Fan cable disconnected; Faulty fan header; Fan failure | Check fan cable connection to motherboard; Try a different fan header; Replace cooler if fan is faulty. |
| CPU温度が高い | Improper cooler mounting; Insufficient thermal paste; Dust accumulation; Poor case airflow | Re-seat cooler, ensuring even pressure; Reapply thermal paste; Clean heatsink and fan; Improve case ventilation. |
| ファンの騒音が大きすぎる | Dust in fan bearings; Fan hitting cables; High fan speed due to high CPU load | Clean fan; Ensure no cables are obstructing fan blades; Check CPU load and temperatures; Adjust fan curve in BIOS/UEFI if desired. |
8. 仕様
Key technical specifications for the Xilence Performance C CPU Cooler XC032:
| 特徴 | 仕様 |
|---|---|
| モデル番号 | XC032 |
| 製品寸法 | 3.94 x 3.94 x 3.15 インチ (10 x 10 x 8 cm) |
| 重さ | 11.46オンス（325グラム） |
| 互換性のあるソケット | Intel LGA 1150, 1151, 1155, 1156 |
| 対応デバイス | Core i7/i5/i3, Pentium G9650 |
| 冷却方法 | 空気 |
| ファン径 | 92ミリメートル |
| ファンコネクタ | 4ピンPWM |
| 最高回転数 | 2500 回転 |
| 風量 | 44.25 CFM (75.2 M³/H) |
| 騒音レベル | 26.4デシベル |
| TDP（熱設計電力） | 最大95ワット |
| 巻tage | 12ボルト |
| 材料 | アルミニウム |
9. 保証とサポート
For warranty information and technical support, please refer to the documentation provided with your purchase or contact the retailer/manufacturer directly. Xilence products typically come with a manufacturer's warranty covering defects in materials and workmanship.
- メーカー Webサイト： Visit the official Xilence web最新のサポート リソース、FAQ、および連絡先情報については、こちらのサイトをご覧ください。
- 購入証明: Retain your proof of purchase (receipt or invoice) as it may be required for warranty claims.
