マニュアル+

WAC Lighting 3021-27WT

WAC Landscape Lighting Cone LED 12V Deck and Patio Light Instruction Manual

モデル: 3021-27WT

1. 安全情報

Please read these instructions carefully before installation and retain them for future reference. Failure to follow these instructions may result in electric shock, fire, or other hazards.

  • 電気安全: This product operates on a 12V AC/DC low voltage system. A compatible 12V magnetic or electronic power supply (transformer) is required and sold separately. Do not connect directly to 120V AC.
  • インストール: Installation should be performed by a qualified electrician or trained professional in accordance with local electrical codes. Ensure power is disconnected at the source before installation or servicing.
  • 屋外での使用: The fixture is IP66 rated, indicating protection against high-pressure water jets and outdoor elements. Ensure all connections are watertight using the provided gel-filled wire nuts.
  • 調光： For dimming functionality, use a Magnetic Low Voltage (MLV) dimmer (sold separately).
  • 製品の完全性: 器具を改造しないでください。改造すると保証が無効になり、安全上の危険が生じる可能性があります。

2. パッケージ内容

インストールを開始する前に、すべてのコンポーネントが揃っていることを確認してください。

  • WAC Landscape Lighting Cone LED Deck and Patio Light (Model 3021-27WT)
  • 3-foot lead wire (attached to fixture)
  • 2 x Ideal Direct Burial Wire Nuts (gel-filled)
  • Hardware Pack for Surface Mount
WAC Landscape Lighting Cone LED Deck and Patio Light, white, with attached wire and wire nuts

Image: The WAC Landscape Lighting Cone LED Deck and Patio Light in white, showing the attached lead wire and two gel-filled direct burial wire nuts.

3. セットアップとインストール

This fixture is designed for surface mounting on a flat surface, such as a 4x4 post or deck railing. A 12V AC/DC landscape lighting transformer (sold separately) is required.

3.1 必要なツール（付属していません）

  • ドリル
  • Drill bits appropriate for mounting surface and wire passage
  • ドライバー
  • ワイヤストリッパ
  • 巻tageテスター

3.2 インストール手順

  1. 電源を切る: Ensure the power supply to the landscape lighting system is turned off at the main breaker or transformer.
  2. 取り付け面の準備: Select a suitable location for the light. The fixture is designed to fit cleanly on a 4x4 post without hanging off the sides. Mark the desired mounting points for the screws from the hardware pack.
  3. パイロット穴をドリルで開ける: Drill pilot holes for the mounting screws. If routing the wire through the mounting surface, drill an additional hole for the lead wire.
  4. 器具を取り付ける: Secure the light fixture to the mounting surface using the provided hardware. Ensure it is firmly attached.
  5. 配線を接続:
    • Strip approximately 1/2 inch of insulation from the ends of the fixture's lead wire and the main low voltage landscape wire.
    • Twist the exposed copper wires together (one from the fixture to one from the main wire).
    • Secure each connection with a gel-filled direct burial wire nut. Twist the wire nut clockwise until tight. The gel inside the nut will seal the connection, protecting it from moisture.
    • Bury the wire connections underground or ensure they are otherwise protected and concealed.
  6. Transformer に接続します。 Connect the main low voltage landscape wire to your 12V AC/DC landscape lighting transformer (sold separately). Refer to your transformer's manual for specific connection instructions.
  7. 電力を回復する： Once all connections are secure and properly insulated, restore power to the landscape lighting system.
WAC Landscape Lighting 12V Power Supply Transformer

画像: Example of a WAC Landscape Lighting 12V power supply transformer, required for operation (sold separately).

ビデオ: オーバーview of WAC Deck & Patio lights, demonstrating their design and suitability for various installations. This video provides visual context for the product line.

4. 操作

The WAC Landscape Lighting Cone LED Deck and Patio Light operates automatically when connected to a compatible 12V landscape lighting system controlled by a timer or photocell (not included). The light will illuminate when power is supplied to the low voltage回路。

  • 電源オン/オフ: Control the light by turning the 12V landscape lighting transformer on or off.
  • 調光： If connected to a Magnetic Low Voltage (MLV) dimmer, the brightness can be adjusted smoothly and continuously down to 10% of its maximum output.
  • 光出力: This model provides 2700K Warm LED light, offering a soft, inviting glow suitable for decks, patios, and pathways.
Comparison of 2700K Warm and 3000K Warm White LED light output

Image: A visual comparison showing the difference between 2700K Warm light (left) and 3000K Warm White light (right). This specific model emits 2700K Warm light.

5. メンテナンス

The WAC Landscape Lighting Cone LED Deck and Patio Light is designed for minimal maintenance. The built-in LED has a rated life of 50,000 hours.

  • クリーニング： 定期的に柔らかい布で器具を清掃してください。amp cloth to remove dirt and debris. Do not use abrasive cleaners or solvents, as these can damage the finish or lens.
  • 検査： Annually inspect the wiring and connections for any signs of wear, damage, or corrosion. Ensure wire nuts remain securely fastened.
  • LEDの交換: The LED is built-in and not user-replaceable. If the LED fails within the warranty period, contact customer support.

6。 トラブルシューティング

If your WAC Landscape Lighting Cone LED Deck and Patio Light is not functioning as expected, refer to the following common issues and solutions:

問題考えられる原因解決
ライトが点灯しません。
  • 変圧器に電力が供給されていません。
  • Loose or faulty wire connections.
  • 変圧器の故障。
  • 破損した器具。
  • Check if the transformer is plugged in and receiving power. Verify circuit breaker.
  • Inspect all wire connections, ensuring they are tight and properly sealed with wire nuts.
  • Test the transformer output voltage. 必要に応じて交換してください。
  • If other lights on the same circuit work, the fixture may be faulty. Contact customer support.
光がちらついたり暗くなったりする。
  • 変圧器からの電力が不足しています。
  • ワイヤー接続が緩んでいる。
  • 互換性のない調光器。
  • Ensure the transformer wattage is sufficient for all connected lights.
  • すべての配線接続を確認して締めます。
  • If using a dimmer, ensure it is a Magnetic Low Voltage (MLV) dimmer.
器具内部に水が入っています。
  • Improperly sealed wire connections.
  • Damage to the fixture housing.
  • Ensure wire nuts are twisted tightly and fully encapsulate the wire connection.
  • Inspect the fixture for cracks or damage. Contact customer support if damaged.

7. 仕様

特徴詳細
モデル番号3021-27WT
ブランドWAC照明
製品寸法長さ3.38インチ x 幅1.63インチ x 高さ3.21インチ
材料アルミニウム
色白
光源内蔵LED
入力ボリュームtage9-15V AC / DC
消費電力2.8W（4.6VA）
輝度Up to 60 Lumens (90 Lumens max)
色温度2700K Warm LED
演色評価数（CRI）90
定格時間50,000時間
減光Smooth and continuous to 10% with MLV dimmer (sold separately)
IP 定格IP66 (Factory sealed water tight)
認定資格UL & cUL 1838, EPA, Energy Star, FCC
含まれるコンポーネントFixture, 3ft lead wire, 2x direct burial wire nuts, hardware pack
Line drawing with dimensions of the WAC Cone LED Deck Light

Image: Technical line drawing showing the dimensions of the WAC Cone LED Deck and Patio Light.

8.保証とサポート

保証： This WAC Landscape Lighting product is covered by a 10-year functional warranty and a 2-year finish warranty from the date of purchase. This warranty covers defects in materials and workmanship under normal use.

除外事項: The warranty does not cover damage caused by improper installation, misuse, abuse, accidents, modifications, or acts of nature. It also does not cover normal wear and tear or consumable parts.

カスタマーサポート: For technical assistance, warranty claims, or replacement parts, please contact WAC Lighting customer service. Have your model number (3021-27WT) and proof of purchase ready.

WAC Lighting Contact Information:

  • 訪問する AmazonのWAC照明ストア 詳細についてはこちらをご覧ください。
  • Refer to the official WAC Landscape Lighting web直接の連絡先の詳細については、サイトをご覧ください。

関連文書 - 3021-27WT

前view WAC Colorscaping セットアップガイド: インストール、アプリの構成、自動化
このWAC Colorscapingセットアップガイドでは、スマートランドスケープ照明システムのインストールと設定方法をステップバイステップで解説しています。準備手順、MyWACアプリを使用したアプリのセットアップ、ユーザーアクセス（所有者/管理者アカウント）の管理、屋外照明のカスタムオートメーションの作成などについて詳しく説明します。
前view WAC メッシュ ゲートウェイ WH-GW1-WT インストール手順
電源、構成、FCC 準拠情報を含む、WAC メッシュ ゲートウェイ WH-GW1-WT のインストール手順。
前view WAC RCUV-WT スマートファンリモコン操作説明書
WAC RCUV-WT スマートファン リモコンの操作に関する包括的なガイド。ペアリング、ファンとライトの操作、ブリーズ モード、UV 自動オフ、Wi-Fi 設定、トラブルシューティングなどを網羅しています。
前view WAC Lighting LED Step and Wall Lights Installation Guide (12V Models 4031-4091)
Comprehensive installation instructions for WAC Lighting's 12V LED Step and Wall Lights, including models 4031, 4041, 4051, 4061, 4071, and 4091. Covers safety warnings, dimensions, hardware, and step-by-step wiring and mounting procedures.
前view WAC InvisiLED RGBWW T24-CC1 取付説明書
WAC InvisiLED RGBWW LED テープ ライト (モデル T24-CC1) の包括的なインストール ガイドです。重要な安全上の注意事項、配線オプション、取り付け手順、システム図、最適なパフォーマンスを実現するためのトラブルシューティングのヒントを網羅しています。
前view WAC Lighting Volta 2インチ 調光可能ホワイト リモデルハウジング 透明トリム 取り付けガイド
この文書は、WAC Lighting Volta 2インチ 調光可能ホワイト リモデルハウジング インビジブルトリム（型番：R2RRLおよびR2SRL）の包括的な設置手順を記載しています。重要な安全上の注意事項、設置要件、寸法データ、技術仕様、そして適切な設置のための詳細な手順ガイドが含まれています。