Compustar 700R Remote Starter Replacement Remote User Manual

1. はじめに

This manual provides comprehensive instructions for the proper setup, operation, and maintenance of your Compustar 700R replacement remote for remote starter systems. Please read this manual thoroughly before attempting to use or program your new remote to ensure correct functionality and to avoid potential issues.

The Compustar 700R is designed as a direct replacement for compatible Compustar remote starter systems, offering reliable control over your vehicle's remote start, lock, unlock, and other auxiliary functions.

Image: The Compustar 700R replacement remote, a compact black device with multiple control buttons for vehicle functions.

2. 安全情報

• リモコンを水や過度の湿気から遠ざけてください。
• リモコンを極端な温度（高温または低温）にさらさないでください。
• Do not attempt to disassemble or modify the remote control. This may void the warranty and cause damage.
• 使用済みの電池は地域の条例に従って廃棄してください。電池を焼却しないでください。
• 電池はお子様の手の届かないところに保管してください。 飲み込んだ場合は、直ちに医師の診察を受けてください。

3. パッケージ内容

パッケージに次のアイテムが含まれていることを確認してください。

• Compustar 700R Replacement Remote (1 unit)
• Lithium Metal Battery (pre-installed or separate, typically 1 unit)

If any items are missing or damaged, please contact your retailer or Compustar support.

4. セットアップ

4.1 バッテリーの取り付け

The Compustar 700R remote typically comes with a pre-installed battery. If you need to install or replace the battery, follow these steps:

1. リモコンの背面にある電池ケースのカバーを見つけます。
2. Carefully open the cover using a small coin or screwdriver if necessary.
3. Insert the new Lithium Metal battery (e.g., CR2032) with the positive (+) side facing up, observing the polarity markings inside the compartment.
4. 電池カバーをしっかりと閉じてください。

4.2 リモコンのプログラミング

The 700R remote must be programmed to your vehicle's Compustar remote starter system to function. The programming procedure can vary slightly depending on your specific Compustar system and vehicle model. Always refer to your vehicle's remote starter system manual for the most accurate programming instructions. A common programming method involves the following general steps:

1. バレットスイッチを見つけます: Find the Valet switch in your vehicle. This is usually a small button located near the steering column, under the dash, or in the fuse box area.
2. プログラミングモードに入る：
   • Insert your vehicle's key into the ignition.
   • イグニッションをONの位置に回します（エンジンは始動しないでください）。
   • Within 5 seconds, press and release the Valet switch 5 times. The vehicle's parking lights should flash, or the horn may chirp, indicating entry into programming mode.
3. リモコンをプログラムする:
   • While the system is in programming mode, press and hold the ロック button (or the primary function button) on your new 700R remote for approximately 2 seconds.
   • The vehicle's parking lights should flash again, or the horn may chirp, confirming that the remote has been programmed.
4. プログラミングモードを終了します。 Turn the ignition OFF. The system will automatically exit programming mode after a few seconds of inactivity.
5. リモコンをテストします。 Test all functions of the remote (lock, unlock, remote start) to ensure successful programming.

注記： If you are programming multiple remotes, program them one after another without exiting programming mode. If an existing remote stops working after programming a new one, you may need to re-program all remotes simultaneously.

5.運用

The Compustar 700R remote provides control over various vehicle functions. Button labels and functions may vary slightly based on your specific Compustar system configuration.

• ロックボタン: Press once to lock the vehicle doors.
• ロック解除ボタン: Press once to unlock the vehicle doors.
• リモートスタートボタン: Press and hold for approximately 2-3 seconds to initiate remote engine start. The vehicle's parking lights will flash, and the engine will start.
• Remote Stop Button: While the engine is running via remote start, press and hold the Remote Start button again for 2-3 seconds to turn off the engine.
• Trunk Release / Auxiliary Button: Press and hold for approximately 2-3 seconds to open the trunk or activate a programmed auxiliary function (e.g., power sliding doors).
• Panic / Car Finder Button: Press and hold for approximately 2-3 seconds to activate the vehicle's alarm (panic mode) or to locate your vehicle in a parking lot (car finder). Press any button to deactivate.

Refer to your Compustar system's main user manual for detailed information on specific button combinations and advanced features.

6. メンテナンス

6.1 電池の交換

When the remote's range decreases or it becomes unresponsive, it may be time to replace the battery. Follow the steps outlined in Section 4.1 Battery Installation. The 700R remote uses one Lithium Metal battery (e.g., CR2032).

6.2 クリーニング

To clean the remote, wipe it gently with a soft, dry cloth. Do not use harsh chemicals, abrasive cleaners, or immerse the remote in water.

6.3 ストレージ

リモコンを長期間使用しない場合は、直射日光や極端な温度を避け、涼しく乾燥した場所に保管してください。

7。 トラブルシューティング

If you continue to experience issues after attempting these troubleshooting steps, please contact Compustar customer support or an authorized dealer.

8. 仕様

• モデル： 700R
• 商品の重量: 0.96オンス
• パッケージ寸法: 4.65 x 2.72 x 0.59インチ
• 電池: 1 個のリチウム金属電池が必要 (付属)
• メーカー部品番号: 700R
• 特集: 人間工学に基づいたデザイン
• 接続技術： Infrared (Note: Some Compustar systems use RF, verify compatibility with your system)
• 色： 黒

9. 保証とサポート

For detailed warranty information regarding your Compustar 700R replacement remote, please refer to the official Compustar website or the warranty card included with your original remote starter system. Warranty terms typically cover manufacturing defects for a specified period from the date of purchase.

If you require technical assistance, have questions about programming, or need to report a defect, please contact Compustar customer support through their official website or consult an authorized Compustar dealer. Providing your product model (700R) and any relevant system information will help expedite support.

オンラインリソース: Visit the official Compustar webFAQ、更新されたマニュアル、サポート連絡先情報が記載されたサイトです。