ボーゲン C20

ボーゲンクラシックシリーズ Amp C20取扱説明書

モデル:C20

1. はじめに

This manual provides essential instructions for the proper installation, operation, and maintenance of your Bogen Classic Series Amp C20. Please read this manual thoroughly before using the product to ensure safe and efficient performance. Retain this manual for future reference.

2. 安全情報

警告:この製品には、カリフォルニア州で癌や先天性欠損症、またはその他の生殖障害を引き起こすことが知られている化学物質が含まれています。

Always observe basic safety precautions when using electrical equipment to reduce the risk of fire, electric shock, and injury to persons.

3.製品オーバーview

The Bogen Classic Series Amp C20 is a single-channel amplifier designed for various audio applications. It features robust construction and reliable performance.

3.1 主な特徴

3.2 パッケージ内容

開梱したら、次の品目が含まれていることを確認してください。

3.3 フロントパネルのコントロールとインジケータ

フロント view of Bogen Classic Series Amp C20 showing controls

Image 1: Front panel of the Bogen Classic Series Amp C20. This image displays the MIC1, MIC2, AUX, and TREBLE control knobs, along with the POWER switch and the "Classic Series" branding.

  1. MIC1 Input Level Control: Adjusts the volume for Microphone Input 1.
  2. MIC2 Input Level Control: Adjusts the volume for Microphone Input 2.
  3. AUX Input Level Control: Adjusts the volume for the Auxiliary input.
  4. TREBLEコントロール: Adjusts the high-frequency response of the audio output.
  5. 電源スイッチ: を切り替えます amplifier's power on and off.

3.4 リアパネルの接続

後方 view of Bogen Classic Series Amp C20 showing connections

Image 2: Rear panel of the Bogen Classic Series Amp C20. This image shows the various input and output connections, including power input and speaker terminals.

The rear panel contains connections for power, microphone inputs, auxiliary inputs, and speaker outputs. Specific details on these connections are provided in the Setup section.

4. セットアップとインストール

4.1 取り付け

The Bogen Classic Series Amp C20 is designed for surface mounting. Ensure the mounting surface is stable and capable of supporting the unit's weight (approximately 4.5 pounds). Allow adequate ventilation around the unit to prevent overheating.

4.2 電気接続

  1. Ensure the POWER switch on the front panel is in the OFF position.
  2. Connect the power cord to a standard 120 Volt AC outlet.

4.3 オーディオ入力接続

オーディオ ソースを背面パネルの適切な入力に接続します。

4.4 スピーカー出力接続

Connect your speakers to the speaker output terminals on the rear panel. Ensure correct polarity (+ to + and - to -) for all speaker connections. Refer to your speaker's manual for impedance matching requirements.

5. 操作

5.1 電源のオン/オフ

  1. 電源を入れるには amplifier, press the POWER switch on the front panel to the ON position. The power indicator (if present) will illuminate.
  2. To power off, press the POWER switch to the OFF position.

5.2 入力レベルの調整

  1. Start with all input level controls (MIC1, MIC2, AUX) set to their minimum position.
  2. Begin playing audio from your desired source.
  3. Slowly increase the corresponding input level control until the desired volume is achieved.
  4. Adjust the TREBLE control to fine-tune the high-frequency response to your preference.

5.3 一般的な使用上のヒント

6. メンテナンス

6.1 クリーニング

外側を拭きます amplifier with a soft, dry cloth. Do not use liquid cleaners or aerosol cleaners, as they may damage the finish or internal components.

6.2換気

適切な空気の流れを確保し、過熱を防ぐために、通気口にほこりやごみが詰まっていないことを定期的に確認してください。

6.3 サービス

内部にはユーザーが修理できる部品はありません。 ampリファイアー。 すべてのサービスは資格のあるサービス担当者に依頼してください。

7。 トラブルシューティング

If you experience issues with your Bogen Classic Series Amp C20, consult the following table before contacting support.

問題考えられる原因解決
音声出力がありません。
  • 電源が接続されていないか、オンになっていません。
  • 入力ソースが接続されていないか、再生されていません。
  • Input level controls set too low.
  • Speaker connections incorrect or loose.
  • Verify power connection and switch position.
  • Check audio source and its connection to the amplifier。
  • 入力レベルコントロールを徐々に上げます。
  • Inspect and secure all speaker wiring.
歪んだ音。
  • 入力レベルが高すぎます。
  • スピーカーのインピーダンスが一致しません。
  • Reduce input level controls.
  • スピーカーが amp増幅器の出力インピーダンス。
Static or crackling from knobs.Dust or oxidation on control potentiometers.Consult qualified service personnel for cleaning or replacement of potentiometers.
Unit becomes excessively warm or emits odor.
  • 換気が悪い。
  • 内部コンポーネントの問題。
  • ユニット周囲に十分な空気の流れがあることを確認してください。
  • Immediately power off the unit and disconnect from power. Contact qualified service personnel.

8. 仕様

特徴詳細
ブランドボーゲン
モデルC20
商品型番C20
メーカー部品番号C20
商品の寸法 (長さ x 幅 x 高さ)11.37 x 7.37 x 2.87インチ
製品寸法11.37 x 7.37 x 2.87インチ
アイテム重量4.5ポンド
巻tage120ボルト
ワットtage50ワット
出力電力20ワット
チャンネル数1
取り付けタイプ表面実装
メーカーボーゲン
欧州連合765368330250
初回利用可能日16年2004月XNUMX日

注:仕様は予告なく変更される場合があります。

9. 保証とサポート

For warranty information and technical support, please refer to the official Bogen webご購入の際は、ウェブサイトをご覧いただくか、カスタマーサービスまでお問い合わせください。保証請求の際は、購入証明としてレシートを保管してください。

連絡先:

関連文書 - C20

前view Bogen NQ-GA20P2 ナイキスト統合電源 Ampライファイア設定マニュアル
Bogen NQ-GA20P2 Nyquist 20ワット統合電源の構成ガイド ampセットアップ、ネットワーク設定、ファームウェアの更新、DSP パラメータの調整などについて説明します。
前view ボーゲン CC4041 CC シリーズ Amplifier インストールおよび使用マニュアル
Bogen CC4041 CC シリーズのインストールおよび使用マニュアル Amp機能、接続、操作、安全に関する指示、技術仕様について詳しく説明します。
前view ボーゲンBPA60パワー Amplifier インストールおよび使用マニュアル
Bogen BPA60 60ワットモノチャンネル電源の包括的なインストールと使用ガイド amp技術仕様、安全上の注意事項、接続図、操作手順、保証情報などを詳しく説明した製品です。
前view Bogen TPU Series Telephone Paging Amplifiers: Installation and Use Manual
Comprehensive installation and use manual for Bogen TPU35B, TPU60B, TPU100B, and TPU250 telephone paging amplifiers, covering setup, wiring, operation, and specifications.
前view Bogen Platinumシリーズ PS120-G2、PS240-G2 パブリックアドレス Amplifier インストールおよび使用ガイド
Bogen Platinumシリーズ公共放送の包括的な設置および使用ガイド Ampライファイア、モデルPS120-G2およびPS240-G2。プロフェッショナルオーディオ設備向けの機能、操作、安全性、トラブルシューティング、技術仕様を網羅しています。
前view Bogen NQ-E7010 ナイキスト入出力コントローラ構成ガイド
このガイドでは、Bogen NQ-E7010 Nyquist入出力コントローラーの設定に関する包括的な手順を説明します。ネットワーク設定の管理、ファームウェアのアップデート、ログへのアクセス、そしてBogen Digital Certification Authorityによる安全なアクセスの確保方法について学習します。