VEVOR 15000 Lumen Three-Head LED Work Light with Tripod Stand

導入

Thank you for choosing the VEVOR 15000 Lumen Three-Head LED Work Light. This manual provides essential information for the safe assembly, operation, maintenance, and troubleshooting of your work light. Please read this manual thoroughly before use and retain it for future reference.

安全に関する注意事項

• 電気安全: 電源がボリュームと一致していることを確認してくださいtage requirements of the light. Do not operate with damaged cords or plugs. Always unplug the light before cleaning or maintenance.
• 配置: Position the tripod on a stable, level surface to prevent tipping. Avoid placing the light near flammable materials.
• 熱： Although LED lights generate less heat than traditional halogen, the light heads can still become warm during operation. Avoid touching the light heads directly when in use.
• 耐水性: This product is IP65 rated for water and dust resistance, suitable for outdoor use in various weather conditions. However, avoid submerging the unit in water.
• 子供とペット: 作業用ライトは子供やペットの手の届かないところに保管してください。
• 使用目的: Use this product only for its intended purpose as a work light. Do not modify the unit.

パッケージ内容

開梱時にすべてのアイテムが揃っていることを確認します。

• 1 x Three-Head LED Work Light Assembly
• 1x三脚スタンド
• ユーザーマニュアル (本書) x 1
• 1 x 35mm Bolt
• 4 x25mmボルト
• 1 x六角レンチ

製品終了view

The VEVOR LED Work Light features three independently adjustable light heads mounted on a height-adjustable tripod stand, providing versatile illumination for various tasks.

Image: The VEVOR 15000 Lumen Three-Head LED Work Light fully assembled on its tripod stand.

主な特徴:

• 高輝度： 15,000 lumens output for wide area illumination.
• 調整可能な色温度: 6000K-6500K for clear, bright white light.
• Independent Light Heads: Each of the three light heads can be individually switched and adjusted for angle.
• 高さ調節可能な三脚: Extends from 43.31 inches (110 cm) to 70.87 inches (180 cm).
• 耐久性のある構造: 屋外での使用に適した IP65 防水・防塵規格。
• 長い電源コード: 10.83 ft (3.3 m) power cord for extended reach.

Image: Illustration showing the 15,000 lumens brightness and 6000-6500K adjustable color temperature of the VEVOR LED Work Light.

Image: Diagram illustrating the multi-angle independent adjustment of the three light heads (180° vertical and horizontal), showing 70 LEDs per light head and the extra-long 10.83 ft power cord.

Image: Illustration of the height-adjustable tripod stand, demonstrating its stable design and showing the adjustment range from 43.31 inches (minimum) to 70.87 inches (maximum).

Image: The VEVOR LED Work Light demonstrating its rugged construction and IP65 waterproof and dustproof rating in a rainy outdoor environment.

セットアップ手順

1. コンポーネントを解凍します: すべての部品をパッケージから慎重に取り出し、「パッケージの内容」リストと照合します。
2. 三脚スタンドの組み立て: Extend the legs of the tripod stand until they are fully spread and stable. Secure any locking mechanisms on the tripod legs.
3. Attach Light Bar to Tripod: Place the light bar assembly onto the top of the tripod stand. Align the mounting holes. Use the provided 35mm bolt and hex wrench to secure the light bar to the tripod.
4. 安全なライトヘッド: The three light heads are pre-attached to the light bar. Ensure they are securely fastened.
5. 高さの調整: 高さ調整クランプを緩めるamps on the tripod pole, extend the pole to the desired height (between 43.31 in and 70.87 in), and securely tighten the clamps.
6. Position Light Heads: Adjust the angle of each light head vertically and horizontally as needed. The individual switches are located on each light head.
7. 接続電源： Plug the power cord into a suitable electrical outlet. Ensure the outlet meets the product's power requirements.

画像: 完全な view of the VEVOR LED Work Light, illustrating the assembled tripod stand and the three light heads with their wiring.

操作手順

1. 電源オン/オフ: Once plugged in, use the individual switch located on each light head to turn it on or off.
2. ライトの角度を調整: Each light head can be independently rotated 180 degrees vertically and horizontally to direct light precisely where needed.
3. 高さの調整: To change the height of the light, loosen the clamps on the tripod pole, adjust to the desired height, and re-tighten the clampしっかりと。
4. 明るさ調整: The light provides a fixed brightness of 15,000 lumens. There is no adjustable brightness feature on this model.

画像: Examples of the VEVOR LED Work Light in use, demonstrating its versatility for both indoor tasks like auto repair and outdoor applications such as construction.

メンテナンス

• クリーニング： Disconnect the power before cleaning. Wipe the light heads and stand with a soft, damp 布で拭いてください。研磨剤や溶剤は使用しないでください。
• ストレージ： When not in use, fold the tripod stand and store the work light in a dry, cool place away from direct sunlight.
• コード検査： Regularly inspect the power cord for any signs of damage, fraying, or cuts. If damaged, discontinue use and replace the cord by a qualified technician.
• 留め具: 定期的にすべてのボルトとクランプを点検してくださいamps to ensure they are tight and secure.

トラブルシューティング

仕様

Image: Diagram illustrating the dimensions and key specifications of the VEVOR LED Work Light, including item model number, rated power, brightness, color temperature, LED quantity, power cord length, net weight, and single light dimensions.

保証とサポート

This VEVOR product comes with a 2-year warranty from the date of purchase. For warranty claims, technical support, or replacement parts, please contact VEVOR customer service. Keep your purchase receipt as proof of purchase.

詳細については、公式VEVORストアをご覧ください。 AmazonのVEVORストア