Hobbywing WP 12BL45 G2

Hobbywing QuicRun WP 12BL45 G2 ESC Instruction Manual

Electric Speed Controller for 1/12 & 1/14 Scale RC Vehicles

1. はじめに

This manual provides essential instructions for the proper installation, operation, and maintenance of your Hobbywing QuicRun WP 12BL45 G2 Electric Speed Controller (ESC). Please read this manual thoroughly before using the product to ensure correct functionality and to prevent damage.

2. 安全上の注意

Always observe the following safety guidelines to prevent personal injury or damage to the product and associated equipment:

  • バッテリー接続: Ensure correct polarity when connecting batteries. Incorrect connection can cause severe damage to the ESC and battery.
  • 絶縁: Always insulate exposed wires to prevent short circuits.
  • 水への露出: While this ESC features IP67 protection, avoid prolonged submersion or exposure to corrosive liquids. Always dry the ESC thoroughly after use in wet conditions.
  • 熱: ESCs can generate significant heat during operation. Ensure adequate ventilation and avoid touching the ESC immediately after use.
  • 巻tage互換性: Only use battery voltages within the specified range (2-3S LiPo). Exceeding this range will damage the ESC.
  • 子供たち: This product is not a toy and is not suitable for children under 18 years of age without adult supervision.

3. パッケージ内容

パッケージにすべてのアイテムが含まれていることを確認します。

  • QuicRun WP 12BL45 G2 speed controller

4. 主な特徴

The Hobbywing QuicRun WP 12BL45 G2 ESC incorporates several design elements for enhanced performance and durability:

  • 連続/ピーク電流: 45A continuous, 200A peak.
  • Battery Cell Compatibility: Supports 2-3S LiPo battery configurations.
  • Built-in High-Power BEC: Provides a continuous current of 4A with a maximum output of 7A, supporting selectable voltages of 6V/7.4V. This allows for precise and responsive control of high-torque and high-voltageサーボ。
  • IP67 High-Level Protection: The ESC features an IP67 protection rating, offering excellent waterproof and dustproof performance. This ensures reliable operation in various weather conditions and harsh environments. Note: The IP67 rating applies under normal usage conditions and has been tested under controlled laboratory conditions. These protective functions are not permanent and may degrade over time due to daily wear and aging. Do not submerge the product in water for extended periods, as this may result in damage.
  • Dedicated Programming Port: Designed with a dedicated programming port, eliminating the need to unplug the throttle cable during parameter adjustments. This port also allows connection of an external cooling fan.
Hobbywing QuicRun WP 12BL45 G2 ESC with Built-in High-Power BEC details

Image: Illustration of the built-in High-Power BEC feature, highlighting its 4A continuous and 7A maximum output, with selectable 6V/7.4V voltages。

Hobbywing QuicRun WP 12BL45 G2 ESC with IP67 High-Level Protection

Image: Visual representation of the IP67 protection, showing the ESC's resistance to splash, water, and dust in different environments.

Hobbywing QuicRun WP 12BL45 G2 ESC with Dedicated Programming Port

Image: Depiction of the dedicated programming port, illustrating how to connect an LCD/LED Program Box and an external cooling fan.

5. セットアップとインストール

Follow these steps for proper installation of the ESC in your RC vehicle:

  1. ESCの取り付け: Securely mount the ESC in a location that allows for good airflow and is protected from impacts. Use double-sided tape or screws as appropriate for your chassis.
  2. モーター接続: Connect the three motor wires from the ESC to your brushless motor. Ensure the connections are firm. If the motor rotates in the wrong direction, swap any two of the three motor wires.
  3. レシーバー接続: Plug the ESC's throttle cable (usually a black, red, and white wire bundle) into the throttle channel (CH2) of your RC receiver.
  4. バッテリー接続: Connect your 2-3S LiPo battery to the ESC's battery input connector. Ensure correct polarity.
  5. スイッチの設置: 電源スイッチを車両のアクセスしやすい場所に取り付けます。
Hobbywing QuicRun WP 12BL45 G2 ESC with all connections

画像: トップダウン view of the Hobbywing QuicRun WP 12BL45 G2 ESC, showing the motor wires, battery connector, receiver cable, and power switch for connection reference.

6. 操作手順

Once the ESC is installed and connected, follow these steps to operate your RC vehicle:

  1. 送信機オン: Turn on your RC transmitter first. Ensure the throttle trim is at neutral.
  2. ESC On: Turn on the ESC using its power switch. The ESC will perform a self-test and emit a series of beeps.
  3. Throttle Calibration (if necessary): If the throttle response is incorrect, perform a throttle calibration according to your transmitter and ESC manual. Generally, this involves holding full throttle, then full brake, then neutral during the ESC's power-up sequence.
  4. 手術: You can now operate your RC vehicle. Start with gentle throttle inputs to familiarize yourself with the controls.
  5. ESC Off: Always turn off the ESC first, then your transmitter, after use.

ESCのプログラミング

The QuicRun WP 12BL45 G2 ESC can be programmed using an optional Hobbywing LCD/LED Program Box. Connect the program box to the dedicated programming port on the ESC. Refer to the program box manual for detailed programming instructions.

7. メンテナンス

定期的なメンテナンスは、ESC の寿命を延ばし、最適なパフォーマンスを確保するのに役立ちます。

  • クリーニング: After each use, especially in dusty or wet conditions, clean the ESC. Use a soft brush or compressed air to remove dust and debris. If exposed to water, dry thoroughly.
  • 検査: すべての配線とコネクタに摩耗、ほつれ、腐食の兆候がないか定期的に点検してください。損傷した部品は直ちに交換してください。
  • ストレージ: Store the ESC in a cool, dry place away from direct sunlight and extreme temperatures. Disconnect the battery when storing.

8。 トラブルシューティング

If you encounter issues with your ESC, refer to the following common problems and solutions:

問題考えられる原因解決
ESCの電源が入らないBattery not connected or discharged; faulty power switch; incorrect wiring.Check battery connection and charge; inspect power switch; verify all wiring.
Motor does not respond or stuttersIncorrect throttle calibration; motor wires loose or incorrectly connected; faulty motor.Perform throttle calibration; check motor wire connections; test with a different motor if possible.
ESCが過熱するOvergearing; insufficient cooling; excessive load; faulty motor.Reduce gearing; ensure adequate airflow; reduce load; check motor for issues.
Vehicle runs in reverse when throttle is applied forwardモーター配線が正しく接続されていません。3 本のモーター ワイヤのうち 2 本を交換します。

9. 仕様

パラメータ価値
連続電流/ピーク電流45A/200A
バッテリーセルの数2 - 3S LiPo
BEC出力6V/7.4V, 4A (7A peak)
寸法(長さ×幅×高さ)39.2 x 29.2 x 25.6 mm (1.54 x 1.15 x 1.01 インチ)
重さ57g (including cables and plugs)
ASINB0F5GFMDZW
メーカー推奨年齢18歳以上
保護等級IP67(防水・防塵)

10. 保証とサポート

保証情報とテクニカルサポートについては、Hobbywingの公式ウェブサイトをご覧ください。 webご購入の際は、サイトをご覧いただくか、お近くの販売店にお問い合わせください。保証請求の際は、購入証明としてレシートを保管してください。

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.