導入
This manual provides instructions for the safe and efficient operation of your CREWORKS Ultrasonic Cleaner, Model SX-DUCV106. This device utilizes ultrasonic cavitation to thoroughly clean various items, including vinyl records, jewelry, glasses, and more. Please read this manual carefully before use and retain it for future reference.
Image: Before and After Cleaning Demonstration
安全に関する注意事項
警告: これらの安全指示に従わなかった場合、感電、火災、または重傷を負う可能性があります。
- Only use with grounded electrical outlets.
- ユニットを分解しないでください。すべての修理は資格のある担当者にご依頼ください。
- Do not operate the unit without water in the tank. Ensure the water level is between the MIN and MAX marks.
- 可燃性、爆発性、腐食性の洗浄液は使用しないでください。
- 濡れた手で電気部品に触れないでください。
- ユニットを子供やペットから遠ざけてください。
- Ensure proper ventilation during operation, as the unit can generate heat.
- 清掃やメンテナンスを行う前に、ユニットを電源から抜いてください。
製品構成
The CREWORKS Ultrasonic Cleaner package includes the following items:
- Ultrasonic Cleaner Unit with Stainless Steel Tank
- 蓋
- 電源コード
- Cleaning Basket (for small items)
- Vinyl Record Washing Rack (holds up to three 7" or 12" records)
- Vinyl Record Drying Rack
- 排水バルブ
Image: Included Components
設定
- Place the ultrasonic cleaner on a stable, level, and heat-resistant surface. Ensure adequate ventilation around the unit.
- Close the drain valve securely.
- Fill the stainless steel tank with water. For enhanced cleaning, a small amount of appropriate cleaning solution can be added. Do not exceed the maximum fill line.
- 電源コードをユニットに接続し、次にアースされた電源コンセントに接続します。
Image: Ultrasonic Cleaner Unit
手術
General Cleaning Procedure
- After filling the tank (see Setup), place the items to be cleaned into the cleaning basket. Ensure items are fully submerged but not touching the bottom of the tank.
- 洗浄バスケットをタンク内に置きます。
- Set the desired cleaning time using the 'TIME +' and 'TIME -' buttons on the control panel. The timer can be set up to 30 minutes.
- Set the desired temperature using the 'TEMP +' and 'TEMP -' buttons. The heater can warm the solution up to 175°F (79°C). Heating can improve cleaning effectiveness for some items.
- Press the 'ON/OFF' button for the ultrasonic function to start cleaning. Press the 'ON/OFF' button for the heater function if heating is desired.
- 設定された時間が経過すると、ユニットは自動的に停止します。
- Carefully remove the cleaning basket and rinse the cleaned items with clean water.
Vinyl Record Cleaning Procedure
- Assemble the vinyl record washing rack and place it over the tank.
- Carefully mount up to three 7-inch or 12-inch vinyl records onto the rack, ensuring the labels are protected from the cleaning solution.
- Lower the records into the tank, ensuring the grooves are submerged in the cleaning solution.
- Set the desired cleaning time and temperature as described in the General Cleaning Procedure.
- Start the ultrasonic cleaning and heating functions.
- Once cleaning is complete, carefully lift the records from the tank.
- Place the cleaned records onto the included drying rack to air dry completely before storage or playback.
Image: Vinyl Records in Cleaning Rack
Image: Record Drying Rack
コントロールパネルオーバーview
デジタル制御パネルにより、洗浄パラメータを正確に設定できます。
- SET TEMP (°C) / ACTUAL TEMP (°C): Displays the set temperature and the current actual temperature of the solution.
- 温度 + / 温度 -: 目標温度を上げたり下げたりするためのボタン。
- ON/OFF (Heater): 加熱機能を有効または無効にします。
- SET TIME (MINUTES SECONDS): Displays the set cleaning duration.
- TIME + / TIME -: Buttons to increase or decrease the cleaning time.
- ON/OFF (Ultrasonic): 超音波洗浄機能を有効または無効にします。
Image: Digital Control Panel
メンテナンス
- タンクの排水: After each use, especially if using cleaning solutions, drain the tank by opening the drain valve. Place a container underneath to collect the liquid.
- タンクのクリーニング: Rinse the stainless steel tank with clean water. Wipe the interior and exterior surfaces with a soft, damp 布。 研磨クリーナーやスチールウールは使用しないでください。
- ストレージ： 保管する前に、本体が完全に乾いていることを確認してください。直射日光や湿気を避け、涼しく乾燥した場所に保管してください。
- 定期点検: Periodically check the power cord for any damage. Ensure the drain valve operates smoothly.
トラブルシューティング
| 問題 | 考えられる原因 | 解決 |
|---|---|---|
| ユニットの電源が入りません。 | No power supply; Power cord not connected; Faulty outlet. | Check power cord connection; Test outlet with another device; Ensure unit is plugged into a grounded outlet. |
| 超音波機能が動作しません。 | Ultrasonic function not activated; Insufficient water in tank. | Press the ultrasonic 'ON/OFF' button; Ensure water level is above MIN mark. |
| Heater not working or overheating. | Heater function not activated; Sensor malfunction; Prolonged operation. | Press the heater 'ON/OFF' button; Allow unit to cool down; If overheating persists, discontinue use and contact support. |
| 洗浄結果が悪い。 | Incorrect cleaning solution; Insufficient cleaning time/temperature; Items not properly submerged. | Use appropriate cleaning solution for item type; Increase cleaning time or temperature; Ensure items are fully submerged. |
| ユニットの騒音が大きすぎます。 | Normal operation sound; Items touching tank walls. | Some operational noise is normal for ultrasonic cleaners. Ensure items are in the basket and not directly touching the tank. Consider operating in a well-ventilated area away from sensitive ears. |
仕様
- モデル： SX-DUCV106
- タンク容量: 1.6ガロン（6リットル）
- 超音波パワー： 180W
- 火力： 最大200W
- 超音波周波数： 40kHz
- タイマー設定 0-30 minutes (Digital)
- 温度設定： Up to 175°F (79°C) (Digital)
- タンク材質： 304ステンレススチール
- 製品寸法: 約12.8×6.9×10.2インチ
- 商品の重量: 約10.5ポンド
画像: 製品寸法
保証とサポート
CREWORKS products are designed for durability and performance. For any questions, technical assistance, or warranty claims, please contact CREWORKS customer service. Please have your model number (SX-DUCV106) and purchase information ready when contacting support.
For the most up-to-date contact information, please visit the official CREWORKS webサイトを参照するか、購入書類を参照してください。