Digi-Pas DWL280PRO デジタルトルペードレベル ユーザーマニュアル

導入

The Digi-Pas DWL280PRO is a 3rd-generation innovative digital torpedo level designed for professional use. It features a robust, waterproof (IP67) and shock-proof design, advanced LED display technology, and a magnetic V-groove base. This manual provides essential information for the proper setup, operation, and maintenance of your DWL280PRO digital level.

Figure 1: Digi-Pas DWL280PRO Digital Torpedo Levels

This image shows two Digi-Pas DWL280PRO digital torpedo levels, highlighting their compact form factor and the clear, bright LED display. Each level features a traditional bubble vial alongside the digital readout, and is marked "WaterProof—IP67".

設定

バッテリーの取り付け

The DWL280PRO operates on standard batteries. To install or replace batteries:

1. バッテリー コンパートメント カバーを見つけます。通常はデバイスの背面または側面にあります。
2. 小さなドライバーまたはコインを使用してコンパートメントを開きます。
3. 正しい極性 (+/-) を確認して、新しい電池を挿入します。
4. バッテリーコンパートメントカバーをしっかりと閉じます。

初期電源オン

電源ボタンを押します（red button with power symbol) to turn on the device. The LED display will illuminate, showing the current angle or slope.

操作手順

基本的な測定

Place the base of the DWL280PRO firmly on the surface you wish to measure. The digital display will instantly show the angle relative to horizontal. For vertical measurements, the display will automatically invert when the gauge is upside down, ensuring readability.

Figure 2: Measuring a Vertical Surface

This image demonstrates the use of the Digi-Pas DWL280PRO digital level for vertical measurements. A hand holds the level against a metal shelving unit, utilizing its magnetic V-groove base to securely attach to the surface. The bright LED display clearly shows a 90.00-degree reading, indicating a perfectly vertical alignment.

表示単位の変更

を押す UNIT button (blue button with two arrows) to cycle through different measurement units: degrees (°), slope (%), mm/M, and inch/FT.

Setting Reference Angle / Zero Function

To set a relative zero point, place the level on your desired reference surface and press the ZERO button (green gear icon). The display will show 0.00°, and subsequent measurements will be relative to this new zero.

ブザー機能

The DWL280PRO features an audible buzzer that sounds at 0° or any user-set angle, providing an auditory cue for precise alignment.

Figure 3: Buzzer Indication

この画像はクローズアップです view of the Digi-Pas DWL280PRO's bright LED display, showing a reading of 0.00 degrees. A prominent speaker icon is overlaid, indicating the active buzzer function which provides an audible alert when the level reaches 0 degrees or a user-defined angle.

メンテナンス

クリーニング

ソフトでデバイスを拭いてください、damp cloth. Do not use abrasive cleaners or solvents. The DWL280PRO is waterproof (IP67), allowing for cleaning under running water if necessary, but ensure the battery compartment is securely sealed.

図4: 防水機能

This image vividly illustrates the waterproof capability of the Digi-Pas DWL280PRO digital level. The device is shown partially submerged in water, with splashes around it, confirming its IP67 rating and suitability for use in wet environments or for easy cleaning.

ストレージ

Store the level in a dry place, away from extreme temperatures and direct sunlight, when not in use for extended periods.

トラブルシューティング

• ディスプレイがオンにならない: 電池の取り付けを確認し、電池が消耗していないことを確認してください。必要に応じて交換してください。
• 不正確な読み取り: Perform a user re-calibration. The DWL280PRO allows for easy re-calibration back to factory settings without special fixtures. Refer to the full product manual for detailed re-calibration steps.
• ブザーが鳴らない: Ensure the buzzer function is enabled (if applicable) or check if the angle is within the set buzzer range.

仕様

図5: 極度の温度動作

This image shows the Digi-Pas DWL280PRO digital level in a snowy, cold outdoor setting, emphasizing its ability to operate in freezing temperatures. The graphic highlights an operating temperature range of -20°C to 60°C (-4°F to 140°F), showcasing its ruggedness for various environmental conditions.

図6: 製品寸法

This image provides a visual representation of the Digi-Pas DWL280PRO's dimensions, showing a hand holding the level. An overlay indicates a height of 2.4 inches (6 cm), giving a clear idea of its compact size.

保証とサポート

For warranty information and technical support, please refer to the official Digi-Pas web公式サイトをご覧いただくか、カスタマーサービスまでお問い合わせください。保証請求の際は、購入証明としてレシートを保管してください。

Visit the official Digi-Pas Store for more information: Digi-Pas Store on Amazon