Caso Design HW.500

Caso Design HW.500 Touch Turbo Hot Water Dispenser

取扱説明書

Model: HW.500 | Brand: Caso Design

導入

The Caso Design HW.500 Touch Turbo Hot Water Dispenser is engineered for efficiency and convenience, providing hot water to your desired temperature in seconds. This manual provides essential information for the safe and effective use of your appliance.

主な特徴:

  • Heats water to a boil (212°F) in approximately 8 seconds.
  • Equipped with a powerful 1800-watt heating element.
  • Intuitive sensor-touch control panel for ease of use.
  • Offers 6 adjustable temperatures for various beverages.
  • Features 4 adjustable cup sizes to accommodate different needs.
Caso Design HW.500 Hot Water Dispenser, angled view

図1: 角度付き view of the Caso Design HW.500 Hot Water Dispenser.

設定

  1. 開梱: Carefully remove all packaging materials and inspect the dispenser for any damage. Retain packaging for future transport if needed.
  2. 配置: Place the appliance on a stable, flat, heat-resistant surface, away from direct sunlight and heat sources. Ensure adequate ventilation around the unit.
  3. 初期クリーニング: Before first use, clean the water tank and drip tray with warm, soapy water. Rinse thoroughly and dry. Wipe the exterior of the unit with a damp 布。
  4. 水タンクの設置: Fill the removable water tank with fresh, cold tap water up to the MAX line. Ensure the water filter is correctly inserted into the tank. Place the filled water tank securely onto the base of the dispenser.
  5. 電源接続: 電源コードをアース付きコンセントに差し込みます。ディスプレイが点灯し、使用可能状態になったことを示します。
  6. 初回使用サイクル: It is recommended to run at least two full cycles of hot water (at the highest temperature setting) without consuming the water to flush out any manufacturing residues.
Caso Design HW.500 Hot Water Dispenser with water tank visible

図2:側面 view showing the transparent water tank with water level markings.

操作手順

  1. 電源オン: Ensure the dispenser is plugged in and the water tank is filled. The digital display will show the current status.
  2. 温度を選択してください: Use the temperature selection buttons on the sensor-touch control panel to choose your desired water temperature. Available temperatures typically range from 100°F to 212°F (boiling).
  3. Select Cup Size (if applicable): If your model supports adjustable cup sizes, use the corresponding buttons to select the volume of water to dispense.
  4. 給水: Place a cup or container on the drip tray. Press the dispense button. The unit will rapidly heat and dispense the selected amount of water at the chosen temperature.
  5. 分配を停止: To stop dispensing water before the selected volume is reached, press the dispense button again.
  6. 安全ロック: Some models include a safety lock feature. Refer to the display icons for activation and deactivation to prevent accidental dispensing.
Close-up of the Caso Design HW.500 control panel with digital display and touch buttons

図3:詳細 view of the sensor-touch control panel for temperature and dispense settings.

メンテナンス

クリーニング

  • 外観: 外側は柔らかくて乾いた布で拭いてください。amp 布で拭いてください。研磨剤入りの洗剤を使用したり、本体を水に浸したりしないでください。
  • 受け皿: Regularly empty and clean the drip tray. It is removable for easy cleaning.
  • 水タンク: Clean the water tank periodically with warm, soapy water. Rinse thoroughly to remove all soap residue.
Removable drip tray of the Caso Design HW.500 Hot Water Dispenser

Figure 4: The removable drip tray for easy cleaning and maintenance.

脱スケール

Mineral deposits (limescale) can build up over time, affecting performance. Descale your dispenser regularly, especially in areas with hard water.

  • Use a commercial descaling solution suitable for hot water dispensers, following the manufacturer's instructions.
  • あるいは、白酢と水(1:1 の比率)の溶液を使用することもできます。
  • Run the descaling solution through the unit, then rinse by running several cycles of fresh water.

フィルターの交換

The water filter should be replaced according to the manufacturer's recommendations or if you notice a decrease in water quality or flow rate. Refer to the filter packaging for specific instructions.

トラブルシューティング

問題考えられる原因解決
水が出ません。水タンクが空か、正しく装着されていません。Fill water tank or ensure it is correctly installed.
水が十分に熱くない。Incorrect temperature setting. Limescale buildup.Adjust temperature setting. Descale the unit.
遅い水の流れ。Limescale buildup. Clogged filter.Descale the unit. Replace the water filter.
ユニットの電源が入りません。差し込まれていません。電源が切れていますtage.Check power connection. Verify power supply.

仕様

特徴詳細
ブランドカソデザイン
モデル番号HW.500
製品寸法(奥行き×幅×高さ)10.7インチ x 6.6インチ x 12.05インチ
容量Approximately 4.6 Pounds (equivalent to 2.1 Liters)
材料プラスチック
ワットtage1800ワット
巻tage120ボルト
ヒューマンインターフェイス入力タッチスクリーン
フィルタータイプ再利用可能
含まれるコンポーネントHot water dispenser, 1 water filter, manual, warranty
Dimensions of the Caso Design HW.500 Hot Water Dispenser

Figure 5: Product dimensions for placement and space planning.

保証とサポート

This Caso Design HW.500 Hot Water Dispenser comes with a 12ヶ月の限定保証 ご購入日より1年間有効です。保証請求の際は購入証明書を保管してください。

For technical support, service, or to inquire about replacement parts, please contact Caso Design customer service. You can find contact information and additional resources on the official Caso Design webサイトまたは小売店を通じてご購入いただけます。

訪問する Caso Design Store 詳細についてはこちらをご覧ください。

© 2026 Caso Design. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.