Kobalt 80-Volt Max Baretool 16-in Straight Cordless String Trimmer 2nd Generation
Kobalt 80ボルトマックス コードレスストリングトリマー 取扱説明書
Model: 80-Volt Max Baretool 16-in Straight Cordless String Trimmer 2nd Generation
1.製品オーバーview
The Kobalt 80-Volt Max Baretool 16-inch Straight Cordless String Trimmer is a powerful and efficient tool designed for maintaining lawns and gardens. This second-generation model offers robust performance for trimming grass and weeds, providing a clean and manicured finish. It operates on an 80-Volt battery system (battery not included), offering cordless convenience and eliminating the need for gasoline or power cords.

Image: The Kobalt 80-Volt Max Baretool 16-inch Straight Cordless String Trimmer, shown with its straight shaft and trimming head. The blue and grey design highlights its robust construction.
2. 重要な安全情報
Always prioritize safety when operating power tools. Adhere to the following guidelines to prevent injury and ensure safe operation:
- ストリングトリマーを使用するときは、必ず目の保護具と手袋を着用してください。
- 作業エリアから傍観者を安全な距離に保ってください。
- Do not operate the trimmer on wet or slippery surfaces.
- Keep hands and feet away from the cutting path of the string.
- Read and follow all safety instructions provided in the complete user manual before initial use and during subsequent operations.
3. セットアップと組み立て
The Kobalt 80-Volt Max String Trimmer requires minimal assembly. Follow these steps to prepare your trimmer for use:
3.1. ハンドルの組み立て
- Attach the auxiliary handle to the shaft. Ensure it is positioned comfortably for your height and operating style. Tighten securely.
3.2. バッテリーの取り付け
- Ensure the 80-Volt battery is fully charged before use.
- Align the battery pack with the battery port on the trimmer's power head.
- バッテリーをポートに差し込み、カチッと音がするまでしっかりと固定してください。操作中に誤って外れないように、しっかりと固定されていることを確認してください。
3.3. String Head and Line Installation
The trimmer comes with a pre-installed string head. For initial setup or line replacement:
- Ensure the trimmer is turned off and the battery is removed before handling the string head.
- To reload the string, locate the two buttons on the side of the string head. Press these buttons simultaneously to release the spool cover.
- Carefully remove the spool. Follow the directional arrows on the spool to wind new trimmer line evenly.
- Feed the ends of the line through the eyelets on the spool cover.
- Realign the spool cover with the string head and press firmly until it clicks back into place. Ensure the line is properly extended.
4. 操作手順
Once assembled and the battery is installed, your Kobalt 80-Volt Max String Trimmer is ready for use.
4.1. トリマーの始動
- Ensure you are wearing appropriate safety gear, including eye protection and gloves.
- トリマーを両手でしっかりと持ちます。
- Press the safety lock-out button located on the handle.
- While holding the safety button, squeeze the trigger to start the motor. Release the safety button once the motor starts.
4.2. トリミングテクニック
- 掃除: Move the trimmer head from side to side in a sweeping motion to cut grass and weeds.
- テーパリング: Angle the trimmer head slightly to create a clean, tapered edge along sidewalks or driveways.
- エッジング: For precise edging, rotate the trimmer head 90 degrees so the line is vertical to the ground. Walk slowly along the edge.
- ラインの進行: This model features an automatic line advancement system. If more line is needed, lightly tap the trimmer head on the ground while the motor is running.
4.3. Stopping the Trimmer
Release the trigger to stop the motor. Always remove the battery when the trimmer is not in use or before performing any maintenance.
5. メンテナンス
定期的なメンテナンスにより、ストリングトリマーの寿命が長くなり、最適なパフォーマンスが確保されます。
5.1. 清掃
- After each use, remove the battery and use a dry cloth to wipe down the exterior of the trimmer.
- Clean any grass clippings or debris from the cutting head and guard. A small brush can be used for hard-to-reach areas.
- Do not use water or cleaning solvents directly on the motor housing or electrical components.
5.2. String Head Maintenance
- Periodically inspect the string head for wear or damage. Replace if necessary.
- Refer to Section 3.3 for instructions on replacing the trimmer line. Use only the recommended line diameter for optimal performance.
5.3. ストレージ
- トリマーは子供の手の届かない、乾燥した安全な場所に保管してください。
- Remove the battery from the trimmer before long-term storage. Store the battery in a cool, dry place.
6。 トラブルシューティング
This section addresses common issues you might encounter with your Kobalt 80-Volt Max String Trimmer.
| 問題 | 考えられる原因 | 解決 |
|---|---|---|
| トリマーが起動しません。 | Battery not charged or not properly installed. Safety button not pressed. | Ensure battery is fully charged and securely seated. Press the safety lock-out button before squeezing the trigger. |
| トリマーラインが進みません。 | ラインが絡まっているか短すぎます。スプールが空です。 | Tap the trimmer head firmly on the ground while running. If still no advance, remove battery and inspect/re-spool line (refer to Section 3.3). Replace spool if empty. |
| 運転中の過度の振動。 | Improperly wound string on the spool. Damaged cutting head. | Remove battery and inspect the string spool. Ensure line is wound evenly. Check cutting head for any damage and replace if necessary. |
| 切断性能が低下します。 | Dull or worn trimmer line. Overgrown vegetation. | Advance or replace trimmer line. Work in smaller passes for very thick vegetation. |
7. 仕様
- ブランド: コバルト
- モデル: 80-Volt Max Baretool 16-in Straight Cordless String Trimmer 2nd Generation
- 電源: Battery Powered (80-Volt)
- 切断幅: 16インチ
- スピード: 6500 回転
- 商品の重量: 10.03 ポンド
- 製品寸法: 長さ36インチ x 幅9インチ
- 組み立てが必要: はい
- 国際コード: 841821037758
- ASIN: B07MB77SPJ
8. 保証とサポート
For detailed warranty information, please refer to the warranty card included with your product or visit the official Kobalt web技術サポート、部品交換、サービスに関するお問い合わせは、Kobaltの公式チャネルを通じてカスタマーサービスまでご連絡ください。
保証請求を容易にし、重要な製品アップデートを受け取るために、購入時に製品を登録することをお勧めします。
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.