Etronix PHOTON 2.1FW コンボ 取扱説明書

1. はじめに

ご購入ありがとうございますasingの Etronix PHOTON 2.1FW Combo. This high-performance system includes a brushless motor and an Electronic Speed Controller (ESC) designed for remote-controlled vehicles. This manual provides essential information for the safe and efficient operation, setup, and maintenance of your ET0421 combo. Please read this manual thoroughly before use to ensure optimal performance and longevity of your product.

This image displays the Etronix PHOTON 2.1FW Combo, which includes a blue Etronix PHOTON 2Y 3450KV brushless motor, a black Etronix PHOTON 2.1FW 45A Electronic Speed Controller (ESC) with a cooling fan, and a blue Etronix PHOTON Program Card for ESC setup. The motor features gold-plated bullet connectors, and the ESC has various wire leads for connection. The program card shows a digital display and buttons for menu navigation, value adjustment, OK, and reset.

2. 安全上の注意

Always observe the following safety guidelines to prevent injury or damage to the product and surrounding property.

• バッテリーの取り扱い: Use only compatible batteries. Never short-circuit battery terminals. Always disconnect the battery from the ESC when not in use.
• 熱： The motor and ESC can become very hot during operation. Avoid touching them immediately after use to prevent burns. Allow components to cool down before handling.
• 接続: Ensure all connections are secure and correctly polarized. Incorrect wiring can cause damage.
• 水と湿気: This product is not waterproof unless explicitly stated. Avoid exposure to water or high humidity.
• 子供たち： This product is not a toy. Operation should always be supervised by an adult, especially when children are present.
• 換気： Ensure adequate airflow around the ESC and motor to prevent overheating.
• 分解： Do not attempt to disassemble or modify the ESC or motor. This will void the warranty and may cause damage.

3. セットアップとインストール

Follow these steps for proper installation and initial setup of your Etronix PHOTON 2.1FW Combo.

1. モーターの取り付け: Securely mount the Etronix PHOTON brushless motor into your vehicle's motor mount. Ensure proper gear mesh between the motor pinion and spur gear.
2. ESCマウント: Mount the Etronix PHOTON 2.1FW ESC in a location that allows for good airflow and protects it from impacts. Use double-sided tape or screws as appropriate.
3. Motor to ESC Connection: Connect the three motor wires to the corresponding output wires on the ESC. While brushless motors typically do not have polarity for these connections, ensure they are securely fastened (e.g., using bullet connectors). If the motor spins in the wrong direction, swap any two of the three motor wires.
4. ESC to Receiver Connection: Plug the ESC's receiver cable (usually a standard servo plug) into the throttle channel (CH2) of your RC receiver.
5. バッテリー接続: Connect your compatible battery pack to the ESC's battery input leads. Ensure correct polarity (red to positive, black to negative).
6. ESC Calibration (Throttle Range):
   • 送信機をオンにして、スロットル トリムがニュートラルになっていることを確認します。
   • With the ESC off and battery connected, press and hold the ESC's setup button (if available) or follow the specific power-on sequence for calibration (refer to the full ESC manual for precise steps).
   • Turn on the ESC. It will typically emit a series of beeps.
   • Set the throttle stick to full forward, then full reverse, then neutral as prompted by the ESC's LED indicators or beeps.
   • Once calibrated, the ESC will confirm with a final beep sequence.
7. Program Card Usage: The included program card allows for easy adjustment of ESC parameters.
   • Disconnect the ESC's receiver cable from the receiver.
   • Plug the receiver cable from the ESC into the designated port on the program card.
   • Connect a battery to the ESC. The program card will power on.
   • Use the "MENU", "VALUE", "OK", and "RESET" buttons to navigate and adjust settings such as battery type, cut-off voltage, motor timing, brake force, and drag brake.
   • Refer to the program card's specific instructions for detailed parameter descriptions.

4. 操作手順

Once the setup is complete, you are ready to operate your RC vehicle with the Etronix PHOTON 2.1FW Combo.

• 電源オン: Turn on your transmitter first, then connect the battery to the ESC. The ESC will initialize.
• スロットル制御: Push the throttle stick forward on your transmitter to accelerate. Pull it back to brake or engage reverse (if enabled).
• 制動： The ESC provides proportional braking. Pulling the throttle stick back from neutral will apply brakes.
• 逆行する： If reverse is enabled, pulling the throttle stick back a second time (after braking) will engage reverse.
• 電源を切る： Always disconnect the battery from the ESC first, then turn off your transmitter.

5. メンテナンス

Regular maintenance will help ensure the longevity and optimal performance of your Etronix PHOTON 2.1FW Combo.

• クリーニング： After each use, gently clean the motor and ESC to remove dirt, dust, and debris. Use a soft brush or compressed air. Avoid using solvents or liquids.
• 接続: Periodically check all electrical connections (motor wires, battery connectors, receiver plug) for looseness, corrosion, or damage.
• モーターベアリング: Listen for any unusual noises from the motor, which may indicate worn bearings. Replace bearings if necessary.
• ESC Fan: Ensure the cooling fan on the ESC is free from obstructions and spins freely. Clean any dust buildup.
• ストレージ： Store the components in a dry, cool place away from direct sunlight and extreme temperatures.

6。 トラブルシューティング

If you encounter issues with your Etronix PHOTON 2.1FW Combo, refer to the following common problems and solutions.

If the problem persists after attempting these solutions, please contact Etronix customer support or consult a qualified RC hobby technician.

7. 仕様

Key specifications for the Etronix PHOTON 2.1FW Combo (Model ET0421):

注：仕様は予告なく変更される場合があります。

8. 保証とサポート

Etronix products are manufactured to high standards. For information regarding warranty coverage, terms, and conditions, please refer to the official Etronix webサイトをご覧いただくか、お近くの販売店にお問い合わせください。

For technical support, troubleshooting beyond this manual, or spare parts inquiries, please visit the official Etronix webサイトまたは顧客サービス部門に連絡してください。

Etronix Official Webサイト： www.etronix-rc.com