1. はじめに
This manual provides essential information for the safe installation, operation, and maintenance of your CCEI Piccolo PIMT series power supply for pool projectors. The Piccolo PIMT series includes models such as PIMT31 (100W), PIMT33 (300W), and PIMT37 (600W), all operating at 230/12V. This device is designed to power pool projectors safely and efficiently.
Please read this manual thoroughly before installation and use to ensure proper function and to prevent potential hazards.

Figure 1: CCEI Piccolo PIMT Power Supply Unit, top view. This image shows the compact design and the rotary switch for operation.
2. 安全に関する注意事項
警告: Electrical installation must be performed by a qualified electrician in accordance with all local and national electrical codes.
- インストール、メンテナンス、トラブルシューティングを実行する前に、必ず電源を切ってください。
- Ensure the power supply is installed in a dry, well-ventilated area, away from direct sunlight and excessive heat.
- The device is equipped with a waterproof on/off switch, but the main unit should not be submerged or exposed to direct water spray.
- The safety transformer complies with the NF EN61558 standard, ensuring safe operation when installed correctly.
- 最大ワット数を超えないでくださいtage rating of the specific model (e.g., 100W for PIMT31, 300W for PIMT33, 600W for PIMT37).
- Use only original CCEI parts and accessories for replacement or repair.
3. セットアップとインストール
The CCEI Piccolo PIMT power supply is designed for easy installation. Follow these steps carefully:
- 取り付け: Select a suitable location for mounting the power supply unit. Use the provided mounting screws and plugs to securely attach the unit to a vertical surface. Ensure the location allows for adequate ventilation and access for wiring.
- Power Connection (230V AC Input):
- 回路ブレーカーで主電源がオフになっていることを確認します。
- Connect the 230V AC input power cable to the designated terminals on the power supply unit. Refer to the wiring diagram inside the unit cover for correct polarity.
- すべての接続をしっかりと固定します。
- Projector Connection (12V AC Output):
- Connect the 12V AC output cables from the power supply to your pool projector(s).
- Utilize the provided cable glands to ensure a watertight seal where cables enter and exit the unit.
- 合計ワット数を確認しますtage of all connected projectors does not exceed the maximum capacity of your Piccolo PIMT model.
- 最終チェック: Double-check all wiring connections for security and correctness. Ensure all covers are properly closed and sealed.

Figure 2: CCEI Piccolo PIMT Power Supply, showing connection points. This view highlights the input/output terminals and the waterproof switch.
4. 操作手順
Once the power supply is correctly installed and wired, operating it is straightforward:
- 電源オン: Restore power to the unit at the main circuit breaker.
- Activate Projectors: Use the waterproof on/off switch located on the unit to turn your pool projectors ON or OFF. Rotate the switch to the 'ON' position to activate the projectors.
- 電源を切る: To turn off the projectors, rotate the switch to the 'OFF' position. For extended periods of non-use or maintenance, it is recommended to disconnect power at the main circuit breaker.
5. メンテナンス
Regular maintenance ensures the longevity and safe operation of your CCEI Piccolo PIMT power supply.
- クリーニング: 定期的にユニットの外側を柔らかくて乾いた布で拭いてください。amp 布で拭いてください。研磨剤入りの洗剤や溶剤は使用しないでください。清掃する前に、必ず本体の電源を切ってください。
- 検査: Annually inspect all wiring connections for tightness and signs of corrosion or damage. Check cable glands for proper sealing.
- 換気: Ensure that the ventilation openings (if any) are clear of debris to prevent overheating.
- 専門家によるチェック: It is recommended to have a qualified electrician inspect the unit and its connections every few years.
6。 トラブルシューティング
If you encounter issues with your CCEI Piccolo PIMT power supply, refer to the following table:
| 問題 | 考えられる原因 | 解決 |
|---|---|---|
| Projectors do not turn ON. |
|
|
| Unit makes unusual noise or smells burnt. |
|
|
| Intermittent projector operation. |
|
|
If the problem persists after attempting these solutions, contact CCEI customer support or a qualified electrician.
7. 仕様
| 特徴 | 詳細 |
|---|---|
| メーカー | 国際 |
| モデルシリーズ | Piccolo PIMT (PIMT31, PIMT33, PIMT37) |
| 入力ボリュームtage | 230V 交流 |
| 出力巻tage | 12V 交流 |
| Power Output (PIMT31) | 100W |
| Power Output (PIMT33) | 300W |
| Power Output (PIMT37) | 600W |
| 安全基準 | NF EN61558 |
| 特徴 | Waterproof On/Off Switch, Cable Glands, Mounting Screws |
| アイテム重量 | 1.5キロ |
| ASIN | B019YDRZ38 |
| 初回利用可能日 | 21年2020月XNUMX日 |
8. 保証とサポート
CCEI products are manufactured to high-quality standards. For specific warranty information, please refer to the warranty card included with your product or visit the official CCEI webサイトでご確認ください。保証請求に備えて購入証明書を保管してください。
For technical support, spare parts, or service inquiries, please contact your authorized CCEI dealer or visit the CCEI official web連絡先の詳細についてはサイト。