FONESTAR MSH-110 VHF Wireless Microphone System User Manual

導入

This manual provides detailed instructions for the proper setup, operation, and maintenance of your FONESTAR MSH-110 VHF Wireless Microphone System. Please read this manual thoroughly before using the product to ensure optimal performance and longevity.

The FONESTAR MSH-110 is a compact VHF wireless microphone system operating in the 174 to 194 MHz frequency range. It includes a receiver unit and a high-quality unidirectional dynamic handheld microphone, designed for clear audio transmission.

安全情報

火災、感電、怪我のリスクを軽減するために、この製品を使用するときは常に基本的な安全上の注意事項に従ってください。

• ユニットを雨や湿気にさらさないでください。
• cを開けないでくださいasing; すべてのサービスは資格を持った担当者に依頼してください。
• 受信機の周囲に適切な換気を確保してください。
• Use only the provided power adapter for the receiver.
• 責任を持ってバッテリーを廃棄してください。

パッケージ内容

パッケージにすべてのコンポーネントが含まれていることを確認します。

• 1 x FONESTAR MSH-110 VHF Receiver
• 1 x FONESTAR Handheld Wireless Microphone
• 1 x Power Adapter (for receiver)
• Batteries (for microphone)

Image: The FONESTAR MSH-110 system, showing the compact receiver with its antenna and the handheld wireless microphone.

設定

受信機のセットアップ

1. 配置: Position the receiver on a stable, flat surface, away from sources of interference (e.g., computers, Wi-Fi routers). Ensure adequate ventilation.
2. アンテナ： Extend the receiver's antenna fully for optimal signal reception.
3. 電源接続: Connect the provided 12V DC power adapter to the receiver's power input and then plug it into a 230V AC wall outlet. The "POWER" indicator light on the receiver should illuminate.
4. オーディオ出力:
   • Balanced Output (XLR/Cannon): Connect an XLR cable from the receiver's balanced output to a balanced input on your mixer or amplifier. This provides a low-impedance, interference-resistant signal.
   • Unbalanced Output (6.3mm Jack): Connect a 6.3mm jack cable from the receiver's unbalanced output to an unbalanced input on your mixer or amplifier。

マイクの設定

1. バッテリーの取り付け: Unscrew the lower part of the handheld microphone to access the battery compartment. Insert the required AA batteries, ensuring correct polarity.
2. 電源オン: Slide the power switch on the microphone to the "ON" position. The microphone's indicator light should illuminate.

操作手順

システムの電源を入れる

1. Ensure the receiver is connected to power and an audio system.
2. Turn on the receiver. The "POWER" indicator will light up.
3. Turn on the handheld microphone. The microphone's indicator will light up.
4. When the microphone is active and transmitting, the "MIC ON" indicator on the receiver should illuminate, and the "AF" (Audio Frequency) indicator will light up when audio is detected.

音量の調整

• Use the volume control knob on the receiver to adjust the output level of the microphone.
• Further volume adjustments can be made on your connected mixer or amplifier。

スケルチ制御

The receiver features a squelch control to suppress unwanted background noise or static when no audio signal is being transmitted from the microphone. Adjust this control to find the optimal balance between signal reception and noise suppression.

周波数情報

The system operates on a fixed VHF frequency within the 174-194 MHz range, controlled by a quartz crystal. No manual frequency tuning is required or possible.

メンテナンス

• クリーニング： Use a soft, dry cloth to clean the receiver and microphone. Do not use liquid cleaners or solvents.
• バッテリー交換: Replace microphone batteries when the indicator light dims or audio quality degrades. Remove batteries if the microphone will not be used for an extended period.
• ストレージ： システムは直射日光や極端な温度を避け、涼しく乾燥した場所に保管してください。

トラブルシューティング

仕様

保証とサポート

Information regarding warranty coverage and customer support for the FONESTAR MSH-110 system is typically provided at the point of purchase or on the official FONESTAR website. Please refer to your purchase documentation for specific warranty terms and contact information for technical assistance.

For further assistance, please visit the official FONESTAR webサイトをご覧いただくか、お近くの販売店にお問い合わせください。