American International FMK574

American International FMK574 Installation Kit User Manual

For 1996-1999 Ford Taurus and Mercury Sable

1. はじめに

The American International FMK574 Installation Kit is designed to facilitate the installation of an aftermarket single DIN or double DIN car stereo into specific 1996-1999 Ford Taurus and Mercury Sable vehicles. This kit provides the necessary components to integrate your new stereo seamlessly into your vehicle's dashboard, maintaining a factory-like appearance. This manual provides essential information for proper installation and care.

2. 安全情報

Always prioritize safety during any vehicle modification. Failure to follow these guidelines may result in injury, damage to the vehicle, or damage to the product.

  • Disconnect the vehicle's negative battery terminal before beginning any electrical work to prevent short circuits and electrical shock.
  • 安全メガネや手袋などの適切な個人用保護具を着用してください。
  • パーキングブレーキをかけた状態で車両が水平な場所に駐車されていることを確認してください。
  • 作業には適切なツールのみを使用してください。
  • いずれかの手順について不明な点がある場合は、資格のある自動車整備士に相談してください。
  • Do not force components into place. Improper fitment can cause damage.

3. パッケージ内容

Please verify that all components are present before beginning installation. Contents may vary slightly based on manufacturing revisions.

  • Radio Housing/Dash Kit
  • 取り付けブラケット
  • Trim Plate (if applicable)
  • ハードウェア（ネジ、クリップ）
  • Instruction Sheet (basic guide)

Note: This kit typically does not include wiring harnesses, antenna adapters, or tools. These items are usually sold separately and may be required for a complete installation.

4. セットアップとインストール

This section outlines the general steps for installing the FMK574 kit. Specific vehicle disassembly instructions may vary and should be referenced from a vehicle-specific service manual or online resources.

4.1.インストール前

  1. ツールを集める: You will typically need a panel removal tool, screwdrivers (Phillips and flathead), a socket set, wire cutters/strippers, and electrical tape or heat shrink tubing.
  2. バッテリーを外します: Locate your vehicle's battery, usually under the hood. Using a wrench, loosen and remove the negative (-) battery terminal cable. Tuck it away from the battery post to prevent accidental contact.
  3. ワークスペースを準備します。 Ensure adequate lighting and space to work. Protect interior surfaces with a cloth or mat.

4.2. 工場出荷時のラジオの取り外し

  1. Remove Dash Trim: Carefully use a panel removal tool to pry off the factory dash trim surrounding the radio. Start from an edge and work your way around, releasing クリップ。
  2. 工場出荷時のラジオのネジを外す: Once the trim is removed, locate and remove the screws securing the factory radio.
  3. 配線を外す: Gently pull the factory radio out. Disconnect all wiring harnesses and the antenna cable from the back of the radio.
  4. 転送コンポーネント: If your factory dash includes climate controls or other modules integrated into the radio bezel, carefully transfer these components to the new FMK574 dash kit as per the kit's specific instructions.

4.3. Kit Assembly and Aftermarket Radio Installation

  1. ダッシュキットの組み立て: Follow the instructions provided with the FMK574 kit to assemble the radio housing and mounting brackets. This typically involves securing the brackets to the new radio housing.
  2. Mount Aftermarket Radio: Slide your aftermarket stereo into the assembled dash kit. Secure it using the screws provided with the aftermarket stereo or the kit. Ensure it is flush and stable.
  3. 配線接続: Connect the aftermarket wiring harness (sold separately) to your new stereo. Then, connect the vehicle-specific wiring harness adapter (sold separately) to the vehicle's factory wiring. Match wire colors carefully (e.g., yellow to yellow for constant power, red to red for accessory power, black to black for ground).
  4. アンテナ接続： Connect the antenna adapter (if required and sold separately) to the vehicle's antenna cable and then to the aftermarket stereo.
  5. スピーカー配線: Ensure all speaker wires are correctly connected to the aftermarket stereo and the vehicle's speaker wiring. In some vehicles, like the Mercury Sable, you may need to run new speaker wiring from the trunk's computer to the dash for aftermarket speaker systems.
  6. テスト接続: Before fully reassembling, temporarily reconnect the negative battery terminal. Turn on the vehicle and test the new stereo's functionality (power, audio, balance, fade, radio reception, CD/USB/Bluetooth functions).

4.4. 再組み立て

  1. Secure New Radio: Disconnect the battery again. Carefully slide the assembled dash kit with the new stereo into the dashboard opening. Secure it with the screws removed earlier.
  2. Reinstall Dash Trim: Align the dash trim panel and carefully press it back into place until all clips engage. Ensure there are no gaps and the fit is flush. This may require gentle manipulation and patience to achieve a perfect fit.
  3. バッテリーを再接続します: バッテリーのマイナス端子をつなぎ直します。
  4. 最終テスト: Turn on the vehicle and perform a final test of the stereo and any other affected vehicle functions.

5. キットの操作

The FMK574 is an installation kit, not an operational electronic device. Its function is to provide a secure and aesthetically pleasing housing for your aftermarket car stereo. Once installed, the operation of your car stereo will be governed by the stereo's own user manual. The kit itself requires no direct operation.

6. メンテナンス

The FMK574 installation kit is designed for durability and requires minimal maintenance.

  • クリーニング： Clean the visible surfaces of the dash kit with a soft, damp 布で拭いてください。仕上げを傷める可能性のある研磨剤入りの洗剤や溶剤は使用しないでください。
  • 検査： Periodically check that the stereo remains securely mounted within the kit and that the dash trim is still flush. Vibrations from driving can sometimes loosen components over time.

7。 トラブルシューティング

インストール後に問題が発生した場合は、次の一般的な問題と解決策を検討してください。

  • Stereo Not Powering On:
    • Check battery connection: Ensure the negative battery terminal is securely reconnected.
    • Check wiring harness: Verify all power wires (constant 12V, accessory 12V, ground) are correctly connected and secure. Check for blown fuses in the vehicle's fuse box or on the stereo itself.
  • スピーカーから音声が出ない:
    • Check speaker wiring: Ensure all speaker wires are correctly connected to the stereo and the vehicle's wiring harness. Verify polarity (+/-).
    • Check stereo settings: Confirm the stereo's fader and balance settings are not set to an extreme.
  • ラジオの受信状態が悪い:
    • Check antenna connection: Ensure the antenna cable and adapter (if used) are securely connected to the stereo.
    • Verify antenna functionality: The vehicle's antenna may be damaged or disconnected.
  • Dash Kit Does Not Fit Flush / Gaps Present:
    • Re-check internal obstructions: Ensure no wires or components behind the dash kit are preventing it from seating fully.
    • Adjusting fitment: Sometimes, the plastic may need gentle flexing or repeated attempts to achieve a perfect, gap-free fit. Avoid excessive force.
    • Verify correct kit: Double-check that the FMK574 is the correct kit for your specific year, make, and model of vehicle.

8. 仕様

  • モデル番号: FMK574
  • 互換性: 1996-1999 Ford Taurus, 1996-1999 Mercury Sable
  • Supported Radio Sizes: Single DIN, Double DIN (with appropriate trim plate/adapter)
  • 材料： 高級ABSプラスチック
  • 色： Typically black (may vary)
  • 商品の重量: 約2ポンド（0.9kg）
  • パッケージ寸法: 約14.02 x 4.02 x 4.02インチ（35.6 x 10.2 x 10.2 cm）

9. 保証とサポート

American International products are manufactured to high standards. For specific warranty information, please refer to the documentation included with your purchase or visit the official American International website. For technical support or assistance with installation, please contact American International customer service directly.

保証請求のために購入証明書を保管してください。

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.