1. はじめに
This instruction manual provides essential information for the proper installation, maintenance, and troubleshooting of the Candy 92130871 washing machine replacement belt. Please read this manual thoroughly before attempting any installation or repair to ensure safe and effective operation.
2. 安全情報
- Always disconnect the washing machine from the power supply before attempting any installation, maintenance, or repair work. Failure to do so can result in electric shock or serious injury.
- 怪我を防ぐために、手袋などの適切な個人用保護具を着用してください。
- いずれかの手順について不明な点がある場合は、資格のある技術者にご相談ください。
- 修理中は、子供やペットを機器から遠ざけてください。
- すべてのツールが良好な状態にあり、正しく使用されていることを確認してください。
3.製品オーバーview
The Candy 92130871 is an authentic replacement drive belt designed for various Candy washing machine models. This belt is crucial for transmitting power from the motor to the drum, enabling the washing machine to operate correctly.
Image 1: The Candy 92130871 washing machine replacement belt. This image shows the black rubber belt, typically ribbed on one side for grip.
4. 互換性
This replacement belt (Manufacturer Code: 92130871) is compatible with a wide range of Candy washing machine models. Please verify your washing machine's model number against the list below to ensure proper fitment.
互換性のあるモデルは次のとおりです:
- CANDY AC16, ACTIVA50, ACTIVA51, ACTIVA60, ACTIVA61, ACTIVA64SLIM, ACTIVA66SL, ACTIVA6CI
- ALISE060, ALISE065, ALISE066, ALISE'160XT, ALISE190X, ALISE6190X0, ALISE'.610B, ALISE'65 ARG, ALISE'650, ALISE'696
- AQUAV.6, AQUAVIVA60, AQUAVIVA63, AQUAVIVA650, AQUAVIVA66
- C36ZXT, C532, C535T, C536T, C55XT (I), C564XT plata, C577T, C588XT, C58XT (I), C6077T, XT AQUAM, CM.608XT (I)
- C616XT (I), C625XT, C634XT, C634XT (CE), C634XT (NORD), C636XT, C647XT (I), C657XT (I)
- CB52T, CB52TCKD, CB53XTR, CB612XT, CB613TR, CB623XTTR HC, CB62T, CB62TR, CB633XTR, CB634XT, CB63TES, CB63TR, CB63TRCKD, CB63XTR
- CE520T, CE530, CE615, CE621T, CE623R, CE625TR, CE629T, CE637XT, CE650TR
- CG5444T, CG5544T, CG623T, CG644.3T, CG644T, CG654XT, CGAQ665XT
- CH630, CHIARA51XT, CHIARA540XTR, CHIARA552TR, CHIARA55XTR, CHIARA5XT, CHIARA5XTV, CHIARA642XTR, CHIARA65XTR, CHIARA65XT, CHIARA65XTV, CHIARA65XTR, CHIARA65X2XTR, CHIARA6XT
- CI50XTR, CI537T, CI57TR, CI589XT, CI60XTR, CI60XTR H/C, CI620TP, CI622T, CI624T, CI626XT, CI627T, CI637T, CI648XT, CI658XT
- CJ6514, CJ543T, CJ613XT, CJ643T, CJA52T
- CL66XT, CN50T, CN50T-04S, CN60T, CN63T, CN63T CI, CN63TCKD, CN63TRU-03S
- IPC 610, CR61, CS47XT (I), CSB640XTR, CSE640XTR, CSE615XT, CM.SE635XT, CSG624T, CSI615T, CSI635XTR, CSI635XTRSY, CSN62T, CSN62T-03S
- EXCL.S641XTR, EXCLUS.60, EXCLUS.6000, EXCLUS540XTR, EXCLUS65XTR
- HOL165XTR, HOL62, VACANZAS 6, HOLIDAY161, HOLIDAY60, HOLIDAY603, HOLIDAY61
- ICL60T, LADYC.623CKD, SEL.S643XTR, SELEC 0.631 XTR, SELECTA600, SELECTA60X, SELECTA61XXTR
- SL5000EXC, SL50EXCLUS., SLIM644AQUAV, SLIMMY508XT, SLIMMY634XT, SLIMMY655XT, SLIMMY6AQUAV, SLIMMYCB62XT, WM601.
5. インストール（セットアップ）
Replacing a washing machine drive belt requires careful attention. Follow these general steps. Specific machine designs may vary, so refer to your washing machine's primary service manual if available.
- 準備：
- 洗濯機を主電源から外します。
- 機械への給水を止めます。
- Pull the washing machine away from the wall to access the rear panel.
- ベルトにアクセスする:
- 洗濯機の背面アクセス パネルを固定しているネジを見つけて取り外します。
- Carefully remove the panel to expose the motor, drum pulley, and the old belt (if still present).
- 古いベルトを取り外します。
- If the old belt is still partially attached, carefully pry it off the motor pulley and then the larger drum pulley. Note its orientation.
- 新しいベルトを取り付けます。
- First, loop the new Candy 92130871 belt around the smaller motor pulley.
- Next, partially loop the belt around the larger drum pulley.
- While holding the belt firmly on the motor pulley and partially on the drum pulley, slowly rotate the drum pulley by hand. The belt should gradually roll onto the drum pulley until it is fully seated. Ensure the ribbed side of the belt (if applicable) faces the pulleys correctly.
- Check that the belt is centered on both pulleys and has proper tension. It should be snug but allow for a small amount of flex.
- 組み立て直す:
- Replace the rear access panel and secure it with the screws.
- Push the washing machine back into its position.
- Reconnect the power supply and water supply.
- テスト：
- Run a short, empty wash cycle to ensure the belt operates smoothly and quietly.
6. メンテナンス
ドライブベルトを定期的に点検することで、将来の問題を予防し、洗濯機の寿命を延ばすことができます。
- 定期点検： 1 ～ 2 年に 1 回、または異常な音やパフォーマンスの問題に気付いた場合は、ベルトに摩耗、ひび割れ、ほつれ、伸びの兆候がないか点検してください。
- 適切な張力: Ensure the belt maintains proper tension. A loose belt can slip, causing the drum to not spin or spin intermittently. An overly tight belt can put undue stress on the motor and drum bearings.
- 清潔さ: Keep the area around the motor and pulleys free from lint, debris, and moisture, which can affect belt performance and lifespan.
7。 トラブルシューティング
| 問題 | 考えられる原因 | 解決 |
|---|---|---|
| ドラムが回転しない、または回転が遅い | Broken, stretched, or slipped drive belt. | Inspect the belt. Replace if broken or severely worn. Re-seat if slipped. |
| Loud squealing or grinding noise during spin cycle | Worn or misaligned drive belt. | Check belt for wear and proper alignment on pulleys. Replace if worn. |
| 焦げた臭い | Belt slipping due to improper tension or excessive load. | Check belt tension and ensure it's not overloaded. Replace if damaged from slipping. |
If troubleshooting steps do not resolve the issue, it is recommended to contact a qualified appliance technician.
8. 仕様
- ブランド： あめ
- モデル番号: 92130871
- 製品タイプ: Washing Machine Replacement Belt
- 対応デバイス: 洗濯機
- パッケージ寸法: 30 x 20 x 3 cm（約）
- 製品重量: 100g（約）
9. 保証とサポート
For information regarding warranty coverage, technical support, or to purchase additional parts, please refer to the official Candy web購入サイトをご覧いただくか、カスタマーサービス部門にお問い合わせください。購入証明書としてレシートを保管してください。
公式キャンディ Webサイト： www.candy-group.com
