導入
This manual provides detailed instructions for the setup, operation, maintenance, and troubleshooting of your Technoline WS 9136-IT Weather Station. Please read this manual thoroughly before using the device to ensure proper functionality and longevity.
製品終了view
The Technoline WS 9136-IT is a versatile weather station designed to provide accurate indoor and outdoor temperature readings, along with weather forecasts and a radio-controlled clock. It features a clear display and user-friendly controls.
This image shows the Technoline WS 9136-IT Weather Station. The display features the current time (12:34), a DCF signal indicator, a weather forecast icon (partly cloudy), indoor temperature (23.5°C) with max/min values (25°C/18°C), and outdoor temperature (10.3°C) with max/min values (17°C/6°C). Buttons for 'SET', 'ALARM', 'MIN/MAX', and 'RESET' are visible below the display.
主な特徴:
- DCF-77 Radio-Controlled Clock with manual setting option
- 室内と屋外の温度表示
- Min/Max Temperature Memory
- Weather Forecast and Trend Display
- スヌーズ機能付きアラーム
- バッテリー充電レベルインジケーター
- Wall-Mount or Tabletop Use
- Includes Wireless Outdoor Sensor
設定
1. バッテリーの取り付け:
- Open the battery compartment on the back of the main unit and the outdoor sensor.
- Insert the required batteries (typically AA or AAA, refer to the device markings) ensuring correct polarity (+/-).
- 電池ケースをしっかりと閉めてください。
2. センサーの配置:
- Place the outdoor sensor in a shaded, dry location, protected from direct sunlight and rain, to ensure accurate temperature readings.
- Ensure the sensor is within the effective transmission range (868 MHz) of the main unit, typically up to 30 meters in open air. Walls and obstacles may reduce this range.
3. 初期同期:
- After battery installation, the main unit will automatically begin searching for the DCF-77 radio signal for time synchronization and the outdoor sensor signal.
- This process may take several minutes. Ensure the unit is placed away from potential interference sources like electronic devices.
- Once synchronized, the time and outdoor temperature will appear on the display.
手術
1.時間設定：
- 自動: The clock automatically synchronizes with the DCF-77 signal. A signal icon will indicate successful reception.
- マニュアル： If the DCF signal is unavailable, you can manually set the time using the 'SET' button. Press and hold 'SET' to enter time setting mode, then use other buttons (e.g., 'ALARM' or 'MIN/MAX') to adjust values and 'SET' to confirm.
2. 温度表示:
- The display shows current indoor and outdoor temperatures.
- 「MIN/MAX」ボタンを押すと view the recorded minimum and maximum temperatures for both indoor and outdoor environments. Press again to cycle through current, minimum, and maximum values.
- To reset the Min/Max memory, press and hold the 'MIN/MAX' button while the minimum or maximum values are displayed.
3. 天気予報:
- The weather station predicts weather conditions for the next 12-24 hours based on atmospheric pressure changes.
- Icons such as sunny, partly cloudy, cloudy, or rainy will be displayed. Note that these are forecasts and may not always perfectly match current conditions.
4. Alarm Function:
- 「アラーム」ボタンを押すと view 目覚まし時間。
- Press and hold 'ALARM' to enter alarm setting mode. Use other buttons to adjust the hour and minute, and 'ALARM' to confirm.
- To activate/deactivate the alarm, press the 'ALARM' button briefly when the alarm time is displayed. An alarm icon will appear when active.
- When the alarm sounds, press any button (except 'RESET') to activate the snooze function. The alarm will sound again after approximately 5 minutes. Press 'RESET' to turn off the alarm completely.
メンテナンス
1.バッテリーの交換：
- When the battery indicator appears on the display, replace the batteries in both the main unit and the outdoor sensor promptly.
- 必ずすべての電池を同じ種類の新しい電池に同時に交換してください。
2. 清掃：
- ユニットとセンサーを柔らかくて清潔な布で拭いてください。amp 布で拭いてください。研磨剤や溶剤は使用しないでください。
- Ensure no water enters the battery compartments or other openings.
トラブルシューティング
一般的な問題と解決策:
- No outdoor temperature display:
解決： Check batteries in the outdoor sensor. Ensure the sensor is within range and not blocked by thick walls or interference. Try re-synchronizing by removing and reinserting batteries in both units. - Time not synchronizing (DCF-77):
解決： Ensure the unit is placed in an area with good radio signal reception, away from electronic devices. The synchronization process can take several minutes, especially during initial setup or after battery replacement. Manual time setting is an alternative. - 不正確な温度測定値:
解決： For outdoor sensor, ensure it is not in direct sunlight or exposed to heat sources. For indoor unit, ensure it is not near windows, heating vents, or direct sunlight. - ディスプレイが暗い、または空白です:
解決： 本体の電池を交換してください。
仕様
- モデル番号: WS 9136
- 寸法（長さ×幅×高さ）： 12.4 x 2.9 x 13 cm
- 重さ： 158グラム
- 電源: 電池式
- 接続技術： 868 MHz (for outdoor sensor)
- 材料： プラスチック
- 色： Transparent/Silver
保証とサポート
The Technoline WS 9136-IT Weather Station comes with a 2年間保証 ご購入日より1年間有効です。保証請求の際は購入証明書を保管してください。
For technical support or further assistance, please refer to the manufacturer's official webメーカーのウェブサイトをご覧いただくか、カスタマーサービス部門にお問い合わせください。連絡先は通常、製品のパッケージまたはメーカーのウェブサイトに記載されています。 webサイト。